Abstract:In the field of condensed matter physics and materials science, it is of great importance to investigate the microstructures, properties and solidification regularities of liquid metals. In the last few decades, the theories of solidification of binary alloys, such as dendritic growth and eutectic growths have been built. Great progress has also been made on the study of monetectic and peritectic alloys. But a solidification theory on ternary quasiperitectic alloys has not been established up to now. The study of the solidification process of quasiperitectic alloys will provide a basic work for solidification theories of ternary alloys.The master alloy of Al-11.8Cu-24.22Mg was prepared from pure Al (99.99%), pure Mg (99.99%) and Al-54.2Cu in a resistance furnace under CO2 and SF6 (volume proportion is 40 : 1) atmosphere. The melted alloy (840-850 degrees C) was pouring into different quenching graphite crucibles at the same time, and the cooling curves were recorded by a sixteen channels temperature recorder. The graphite crucible was quenched into cold-water immediately for rapid cooling at the preplanned quenching temperature. After the experiment, the microstructures of the sample were analyzed by SEM, with EDS analysis.The experiment result indicates that the primary phase is identified as S (Al2CuMg) and the quasiperitectic phases are alpha-Al and T (Al6CuMg4). The solidification microstructure is composed of remnant primary phase, quasiperitectic phases, binary eutectic and ternary eutectic. Although the quasiperitectic phases and binary eutectic are composed of the same phases (alpha-Al+T(Al6CuMg4)), their structures are different. The former structure presents strip form and the later present dendritic form. The ternary eutectic reaction is suppressed and the remnant primary S phase is reserved in the matrix with non-equilibrating crystallization.

Studies on the thermodynamic and the miscibility gap of the Cu 2O-Al2O3-SiO2 pseudo-ternary system

Studies on the Thermodynamic and the Miscibility Gap of the Cu<sub>2</sub>O-Al<sub>2</sub>O<sub>3</sub>-SiO<sub>2</sub> Pseudo-Ternary System

Application of High Temperature Quantitative X-Ray Powder Diffraction on Determination of Ternary System

Experimental Investigation and Thermodynamic Assessment of Phase Equilibria at the Ti-Mn side in the Ti-Mn-Mo Ternary System

Experimental Investigation of Phase Equilibria in the Co-Ta-Si Ternary System

Phase Equilibria of the Cu-Se-Te Ternary System

Experimental Determination of the Phase Equilibrium in the Mg–Cu–Ca Ternary System at 350 °C

Metastable Phase Diagrams of Cu-based Alloy Systems with a Miscibility Gap in Undercooled State

The Cu–Te system: Phase relations determination and thermodynamic assessment

Experimental study on phase relations in the Al-Mo-Nb ternary system

Phase Equilibria of the Sn–Zn–Cu Ternary System

Experimental investigation and thermodynamic modeling of the Mg-Cu-Ca ternary system

Solidification Mechanism of Ternary Quasi-Peritectic Alloy of Al-11.8cu-24.22mg

SYNTHESIS OF ALLOYS OF THE Sb2Se3-CuCr2Te4 SYSTEM AND PHYSICO-CHEMICAL PROPERTIES

Thermodynamic properties and primary phase structures of ternary Cu90−xSnxSb10 alloys investigated by differential scanning calorimetry and laser flash method

Electronic Origin of the Phase Transition in Ternary Alloy Mo(Si1−x,Alx)2

Thermodynamic study of the Ca-Cu-Zn ternary system with key experimental measurements

Experimental Investigation and Thermodynamic Calculation of Phase Equilibria in the Mg-Pb-Sn Ternary System

Experimental Investigation of Isothermal Sections and Thermodynamic Modeling on the Cu-Nb-Ni System

Study on diffusion characteristics of Al-Cu systems and mechanical properties of intermetallics

Phase equilibria of the Cu-Zr-Ti ternary system at 703 °C and the thermodynamic assessment and metallic glass region prediction of the Cu-Zr-Ti ternary system