Abstract:In this paper, a novel kind of method to monitor corrosion expansion of steel rebars in steel reinforced concrete structures named fiber optic coil winding method is proposed, discussed and tested. It is based on the fiber optical Brillouin sensing technique. Firstly, a strain calibration experiment is designed and conducted to obtain the strain coefficient of single mode fiber optics. Results have shown that there is a good linear relationship between Brillouin frequency and applied strain. Then, three kinds of novel fiber optical Brillouin corrosion expansion sensors with different fiber optic coil winding packaging schemes are designed. Sensors were embedded into concrete specimens to monitor expansion strain caused by steel rebar corrosion, and their performance was studied in a designed electrochemical corrosion acceleration experiment. Experimental results have shown that expansion strain along the fiber optic coil winding area can be detected and measured by the three kinds of sensors with different measurement range during development the corrosion. With the assumption of uniform corrosion, diameters of corrosion steel rebars were obtained using calculated average strains. A maximum expansion strain of 6,738 με was monitored. Furthermore, the uniform corrosion analysis model was established and the evaluation formula to evaluate mass loss rate of steel rebar under a given corrosion rust expansion rate was derived. The research has shown that three kinds of Brillouin sensors can be used to monitor the steel rebar corrosion expansion of reinforced concrete structures with good sensitivity, accuracy and monitoring range, and can be applied to monitor different levels of corrosion. By means of this kind of monitoring technique, quantitative corrosion expansion monitoring can be carried out, with the virtues of long durability, real-time monitoring and quasi-distribution monitoring.

Experimental research on the fiber corrosion sensor based on distributed Brillouin optical time domain reflection technique

Experimental Research on Corrosion-Induced Cracking Monitoring Based on Optical Fiber Sensor

Experimental Research on Monitoring Concrete Expansion and Cracking Induced by Corrosion based on Distributed Optical Fiber Sensor

A New Distributed Optical Fiber Sensor For Structural Health Monitoring - Botdr

Distributed cracks detection by BOTDA and its application in corrosion cracking monitoring

Study on Real-Time Reinforcement Stress Measurement Based on Brillouin Optical Time Domain Analysis

An Experimental Study on the Distributed Monitoring of the Corrosion Expansion of Reinforcing Steel in Concrete Using BOTDR

Fiber-reinforced polymer-packaged optical fiber sensors based on Brillouin optical time-domain analysis

A Novel Method of Embedding Distributed Optical Fiber Sensors for Structural Health Monitoring

Distributed Optical Fiber Sensor-based Monitoring for Foundation Pit Engineering

BOTDR Optic Fiber Temperature Monitoring Technique and Its Application in Civil Engineering

Experimental study on the deformation monitoring of reinforced concrete T-beam using BOTDR

Stain monitoring for tunnel using distributed optical fiber BOTDR sensors

Monitoring the Corrosion Process of Reinforced Concrete Using BOTDA and FBG Sensors

Experimental Investigation of RC Beams Using BOTDA(R)-FRP-OF

STUDY ON DISTRIBUTED OPTICAL FIBER SENSOR-BASED MONITORING FOR SLOPE ENGINEERING

Brillouin Corrosion Expansion Sensors for Steel Reinforced Concrete Structures Using a Fiber Optic Coil Winding Method.

Feasibility Study on Corrosion Monitoring of a Concrete Column with Central Rebar Using BOTDR

Corrosion monitoring and assessment of steel under impact loads using discrete and distributed fiber optic sensors

Distributed Fiber Monitoring Test and Its Application to Slope Deformation

An Optical Fiber Sensor Method for Simultaneously Monitoring Corrosion and Structural Strain Induced by Loading