Silicon-Based Microneedle Array Electrodes for Biopotential Measurement

Yan Xiao-xiao,Liu Jing-quan,Wang Long-fei,Yang Chun-sheng,Li Yi-gui
DOI: https://doi.org/10.4028/www.scientific.net/kem.483.443
2011-01-01
Key Engineering Materials
Abstract:Biopotential signals in shin tissue reflect the body’s healthy conditions. So the measurement of these signals can diagnose whether the body has diseases or not. Traditional technology used to measure these signals results in pain, bleeding, infection, etc. Recently, the microneedle electrodes are used to measure these signals owing to their advantages, such as painless, low cost, easily made, etc. This paper presents a new method to fabricate the silicon-based microneedle array electrodes intended for measuring biopotential signals in the skin tissue. The arrays consist of a 5 mm x 5 mm silicon base with gold film, and 49 silicon needle-type electrodes with gold film in a 7x 7 array on the silicon base. Each needle is approximately 700 μm long, 70μm in diameter at the base. The 1mm-thick silicon wafer is cut to form 300x 300 x700 μm rectangular micro-column by dicing saw. Then the 5x5 mm silicon base with these columns is cut off to form the whole substrate. The rectangular micro-columns are etched in the mixture acid solution (HNO3 and HF) until getting sharp microneedles. Then the surface of the microneedles is sputtered the gold film, the microneedle electrodes are formed. One array of these electrodes exhibits low impedance for measuringbiopotential signals.
What problem does this paper attempt to address?