Abstract:Laser forming has become a viable process for the shaping of metallic and non-metallic sheet components, as a means of rapid prototyping and of adjusting and aligning. In order to advance the laser forming process further for practical application in industry, the research of laser forming was performed on common stainless steel 1Cr18Ni9Ti sheet with a Nd:YAG laser source in this paper. In order to obtain convergent and highly accurate results in a reasonable time, a rezoning technique for laser heat flow density is used to adapt the mesh in the FEM simulations of low-velocity laser forming process, single pulse jump light source is applied in place of continuous scan of laser beam. It includes the empirical investigations to determine processing parameters using the temperature gradient mechanism to form different angles with simple straight line laser scanning. The simulation results of temperature field and deformation field of laser forming of metal sheets accord with the experimental results, which showed that the bending angle increases approximately linearly as the scanning times increase. And the bending angle firstly increases with the laser power increasing and begins to decrease at a certain processing parameters, as there is a certain power parameter resulting in a maximum bending angle for a certain material and parameters. The bending angle increases as the laser beam diameter increase and begins to decrease at a certain processing parameters, as a maximum bending angle is acquired when the beam diameter is the same as the thickness of the metal sheet. Bigger sheet thickness leads to smaller bending angles, and thickness is the most important influencing factor of bending angles. The bending angle increases with the sheet width, but there is a width limit bigger than which the sheet width has little influence on bending angles.

Cooling effects in laser forming

Thermo-Mechanical Coupling Computation and Warping Analysis During Controlled-Cooling of X65 Heavy Pipeline-Plate

The Simulation Of Temperature Field In The Laser Forming Of Steel Plates

An experimental investigation of underwater pulsed laser forming

Thermal Influencing Distribution of Sheet Metal during the Process of Laser Forming

Temperature Field Simulation and Experimental Analysis of Laser Cladding 45 Steel.

Research on the mechanisms of laser forming for the metal plate

Numerical Simulation of the Laser Forming of Plates Using Two Simultaneous Scans

Numerical and experimental investigation of cooling time in laser micro-adjustment of two-bridge actuators

Varying Velocity Scan in Laser Forming of Plates

Modelling of laser forming – An review

Numerical And Experimental Investigation Of Deformation Field During Laser Forming Of Metal Sheet

The effects of cut-out on stress distribution and deformations in laser thermal adjustment

Laser machining technology with the effect of thermal soften and thermal stress

Study on Overlapping of Two Sequential Scans in Laser Forming

Laser Forming of Plates Using Two Sequent Scans of Different Intervals

Temperature-Stress Coupling Fatigue Behavior of Film-Cooling Holes in Complex Temperature Fields

An analytical model based on the similarity in temperature distributions in laser forming

Numerical simulation of the three-dimensional temperature field in laser cladding forming process

Effect of different heating methods on deformation of metal plate under upsetting mechanism in laser forming

Optimization of Laser Cladding Forming Parameters by Numerical Simulation to Minimize the Cracking Posibilitys