Abstract:Previous tensile tests showed that the typical coarse-grained (CG) interstitial high entropy alloy (iHEA) with the nominal composition Fe49.5Mn30Co10Cr10C0.5 (at.%) has higher yield stress and better strain hardening at cryogenic conditions compared to that at room temperature. However, the yield stress of the fine-grained (FG) iHEA is little influenced by decreasing temperature, while the strain hardening is significantly enhanced. The fundamental reasons for these observations need to be further investigated. Thus, a micromechanism-based crystal plasticity model is developed to investigate the temperature effect on the tensile behavior of the iHEA. A thermodynamic model is established to calculate the stacking fault energy of the iHEA at different temperatures. The developed constitutive model is verified by comparing the simulated the stress-strain curves and martensite volume fraction of the CG and FG iHEAs at different temperatures with the corresponding experimental results. Moreover, the contributions of different strengthening mechanisms, such as dislocations, grain boundaries, nano-precipitation, and lattice friction, are quantified to reveal the effect of temperature on the iHEA's yield stress. Furthermore, the grain size effects on deformation twinning and martensite phase transformation are considered. The developed constitutive model is further applied to predict the stress-strain curves of the iHEA with various grain sizes at different temperatures. The present study thus provides a useful modeling tool for understanding the underlying mechanisms of the strength and plasticity in the iHEA, paving a way for optimizing the mechanical properties of advanced alloys at various temperatures.

Temperature Effects on the Mechanical Behavior of Ultrafine-Grained Material

Grain Boundary Sliding and Strain Rate Sensitivity of Coarse and Fine/Ultrafine Grained 5083 Aluminum Alloys

Effect of Strain Rate and Temperature on Dynamic Mechanical Behavior and Microstructure Evolution of Ultra-High Strength Aluminum Alloy

An investigation of the combined size and rate effects on the mechanical responses of FCC metals

Strain localization and ductile fracture mechanism of micro/mesoscale deformation in ultrafine-grained pure copper

The Effect of Temperature on Activation Volume of Ultrafine Grained Tantalum

Microstructural Characteristics and Subsequent Soften Mechanical Response in Transverse Direction of Wrought AZ31 with Elevated Compression Temperature

Temperature effect on tensile behavior of an interstitial high entropy alloy: Crystal plasticity modeling

Microstructures and mechanical properties of Cu-Sn alloy subjected to elevated-temperature heat deformation

Strain Compensation of the Constitutive Equation for High Temperature Flow Stress of a Al-Cu-Li Alloy

Investigation of deformation behavior and strain-induced precipitations in Al-Zn-Mg-Cu alloys across a wide temperature range

Effects of SMAT Temperature and Stacking Fault Energy on the Mechanical Properties and Microstructure Evolution of Cu-Al-Zn Alloys

Thermal Deformation Behavior and Dynamic Softening Mechanisms of Zn-2.0Cu-0.15Ti Alloy: An Investigation of Hot Processing Conditions and Flow Stress Behavior

Grain size effects on the compressibility and yield strength of copper

The effect of temperature on the serrated flow in AA5456 alloys

Plastic Deformation Behavior and Constitutive Modeling of Cu-50Ta Alloy During Hot Compression

Mechanical softening of CuX alloys at elevated temperatures studied via high temperature scanning indentation

Temperature-Dependent Flow Behavior and Microstructural Evolution During Compression of As-Cast Mg-7.7Al-0.4Zn

Coupled Effects of High Temperature and Strain Rate on Compressive Properties of Hybrid Fiber UHTCC

Deformation Behavior and Microstructural Evolution of T-Shape Upsetting Test in Ultrafine-Grained Pure Copper

Achieving high strain rate superplasticity in an Al-Cu-Li alloy processed by thermo-mechanical processing