Abstract:This paper presents an experimental investigation on the flexural behaviour of corroded reinforced concrete (RC) continuous beams strengthened by carbon fabric-reinforced cementitious matrix (C-FRCM). A total of ten specimens with different degrees of corrosion were tested under in-plane bending. The strengthening C-FRCM plates were prefabricated with different layers of carbon fabric meshes for reinforcement, while some specimens were further strengthened by U-shaped wrapping for C-FRCM plates as the end anchorage. The flexural behaviour including failure modes, load-carrying capacities, deflections and redistribution of bending moment were carefully studied. The WA results show that the load-carrying capacities of RC continuous beams were enhanced by the prefabricated C-FRCM plates and the enhancement further increased with the increase of the layer of carbon fabric meshes, in particular the specimens strengthened by U-shaped wrapping that effectively inhibited the debonding of C-FRCM plates. However, the redistribution capacities of the bending moment of RC continuous beams were weakened by the prefabricated C-FRCM plates. The design flexural strengths calculated using the design formulae given in ACI 440.2R-08, ACI 549.4R-13, AC434-0616-R1, FIB Bulletin 14 and CECS 146-2003 (2007) are also compared with the WA flexural strengths, in which ACI 549.4R-13 and AC434-0616R1 are the identical design guidelines for FRCM system, while the other three design guidelines are specific to FRP system. It is shown that the current design guidelines are all conservative for C-FRCM strengthened RC continuous beams, especially the specimens further strengthened by U-shaped wrapping, in which FIB Bulletin 14 provides the best predictions with the smallest value of COV.

Test Study on Strengthening RC Flexural Members with Grouting Material

Experimental Investigation on First Crack Strength and Crack Widthof Reinforced Concrete Beamsby Side-Bonding Cfrp Sheets

Investigation on Flexural Performance of RC Beams Flexurally Strengthened by Side-bonded CFRP Laminates

Study on flexural performance of cracked RC beams retrofitted with CFRP sheets

Effect of sustaining load level on flexural behavior of RC beams retrofitted with CFRP sheets

Effect of Chloride-Induced Reinforcing Steel Corrosion on the Flexural Strength of Reinforced Concrete Beams

Crack Propagation and Flexural Behaviour of Rc Beams under Simultaneous Sustained Loading and Steel Corrosion

Performance of Reinforced Concrete Beams Corroded under Sustained Service Loads: A Comparative Study of Two Accelerated Corrosion Techniques

Investigation On Flexural Behavior Of Reinforced Concrete Beams Flexurally Strengthened By Different Methods

Experimental Study on Flexural Behavior of RC Beams Strengthened with Stainless Steel Wire Mesh and Permeability Polymer Mortar

Experimental Study on Flexural Behavior of Strengthened Corrugated Steel Plate

Experimental study on the effect of grouting reinforcement on the shear strength of a fractured rock mass

CFRP Strengthened RC Beams with Pre-Strengthening Non-Uniform Reinforcement Corrosion Subjected to Post-Strengthening Wetting/drying Cycles

Experimental investigation of corrosion-damaged RC beams strengthened in flexure with FRP grid-reinforced ECC matrix composites

Experimental study on the flexural behavior of RC beams strengthened with prestressed stainless steel wire mesh and permeability polymer mortar

Flexural and Cracking Behavior of Corroded RC Continuous Beams Strengthened with Energized C‐FRCM System

Flexural Behavior of Corroded Concrete Beams Strengthened with Carbon Fiber-Reinforced Polymer

Experimental and analytical study on flexural behavior of corroded RC beams strengthened with CFRP rods and UHPC

Flexural Behaviour of C-FRCM Strengthened Corroded RC Continuous Beams

Strengthening RC Beams with Mid-Span Supporting Prestressed CFRP Plates: an Experimental Investigation

Study of A Reinforced Concrete Beam Strengthened Using A Combination of Sma Wire and Cfrp Plate