Abstract:In order to study the characteristics of fire smoke spread and temperature distribution of a large indoor pedestrian street under different heat release rates and smoke exhaust modes, this paper focuses on the analysis of fire smoke spread, visibility, smoke temperature distribution and variation curves in an atrium. This paper uses a numerical simulation method to conduct research. PyroSim fire simulation software is used to calculate this project, which is based on a full-scale experimental design scheme. The numerical simulation results show that under the conditions of higher heat release rate, the smoke spread rate is greater than that under the conditions of lower heat release rate. Furthermore, the average temperature of smoke in the atrium is also greater, up to about 400 °C. The conditions of a higher heat release rate also show the characteristics of faster generation, faster spread and a larger volume of smoke. When the smoke exhaust system is turned on, the thickness of the smoke layer and the smoke temperature decrease. There then comes a situation where the stabile section of the fire ends in advance. The simulation results of vertical temperature distribution in an atrium can fit the modified McCaffrey plume model in any case. Under all cases, the smoke temperature reaches the maximum directly above the fire source. The horizontal dimensionless smoke temperature rises under the atrium roof, and decreases exponentially with the dimensionless distance from the fire source. The greater the heat release rate of fire source is, the smaller the attenuation coefficient is, with a more than 50% change. When the smoke exhaust system is turned on, the smoke flow accelerates and the smoke is cooled rapidly. Thus, the attenuation coefficient increases. Additionally, the effect of mechanical smoke exhaust is better than natural smoke exhaust, because mechanical smoke exhaust makes air flow and heat exchange more intense. The variation amplitudes of the attenuation coefficient under natural smoke exhaust and mechanical smoke exhaust are 13% and 22%, respectively.

Numerical study on fire smoke control in underground commercial street

Numerical Simulation of Smoke Control in Underground Bus Station

Numerical Simulation of Smoke Control in Underground Space

Study on the Smoke Movement of an Indoor Street Fire Based on Numerical Simulation

Numerical Simulation of Fire in Underground Commercial Street

Numerical Studies on Smoke Spread in Urban Underground Tunnel with Horizontal Junctions

Numerical Study on Smoke Exhaust in Large-Scale Underground Public Buildings

Numerical simulation of smoke control modes in underground railway station fire

Numerical simulation on natural ventilation mode of smoke control in underground railway tunnel fire

Research on Numerical Simulation of Efficiency of Fire Smoke Exhaust of a Underground Driveway

Numerical Investigation on Smoke Movement in a Large Space Building under Fire Scenarios

INFLUENCE OF FIRE-CONTROL MEASURES ON VEHICLE FIRES IN UNDERGROUND CAR PARKS

Numerical Simulation on the Characteristics of Smoke Exhaust Effect with Different Sets of Smoke Vent in Deep Buried Inclined Channel Fire

A Study on Tunnel Smoke Control Strategies by Experiment and Numerical Simulation

Numerical Simulation of Smoke Control Effectiveness with Different Exhaust Modes in a Large Subway Station

Influence of Exhaust Smoke Model on Smoke Control in Tunnel Fire

Numerical Simulation of Smoke Back-layering Length with Different Smoke Exhaust Modes in Subway Tunnel

Numerical Simulation Analysis on Air Supply and Smoke Exhaust Assisted by Jet Fan in Underground Car Park

Numerical Study of Smoke Control for Underground Platform in a High-Speed Railway Station

Numerical Simulation on Smoke Temperature Distribution in a Large Indoor Pedestrian Street Fire

Simulation and Experimental Study of the Fire Performance of Underground Shopping Streets