Abstract:A physical model study was conducted to examine the development of submerged sand erosion through a slot on a defective sewer pipe. Various parameters that affect the erosion process were studied, including particle size, defect size, position on the pipe, and water depth. This experimental study used particle image velocimetry analysis to provide a deeper understanding of the mechanism of sand erosion due to defective sewer pipes. The sand velocities were determined, and the sand and water flow rates were measured. After the erosion process was initiated, the sand and water outflow rates quickly reached the steady state until the eroded zone reached the slot opening. During the steady erosion process, the region of sand motion was restricted to a narrow zone above the opening, with sand particles sliding into the newly formed cavity at the angle of repose. An increase in slot width significantly increased the sand and water flow rates. A decrease in sand particle size from medium to fine resulted in a decreased sand flow rate mainly due to decreased water flow. An increase in sand particle size from medium to coarse resulted in a decreased sand flow rate due to the arching resistance close to the slot for larger sand particles. In this study, the sand flow ceased when the ratio between the slot width and particle size was less than 3.1. The ratio between the sand and water flow rates was found to be a function of the ratio of slot width to particle size. The water level above the pipe and the slot position affected the sand and water flow rates. A simple analytical model was developed to estimate the sand and water flow rates in the erosion process. (C) 2017 American Society of Civil Engineers.

Simulation of Piping Process with Consideration of Pipe Expanding

Numerical Simulation of Serial Sudden Expansions Pipe Flow

Calculation on Mechanical Behaviors of Buried Pipelines Adjacent to Deep Excavation

Elasto-plastic Solution for Tunnelling-Induced Nonlinear Responses of Overlying Jointed Pipelines in Sand

A Coupled Discrete Element Model for the Simulation of Soil and Water Flow Through an Orifice

Numerical Studies on Filter of Piping in Broadly Graded Cohesionless Soils

Numerical Modelling of Pipe-Soil Interaction for Marine Pipelines in Sandy Seabed Subjected to Wave Loadings

Assessment Model of Pipe–soil Interaction During Large-Amplitude Lateral Displacements for Deep-Water Pipelines

Exploring Hydraulic Impacts of Downstream Water Levels on the Drainage Capacity of a Stormwater Pipe

Modeling Soil Loss By Water Infiltration Through Sewer Pipe Defects

Physical modeling on sand erosion around defective sewer pipes under the influence of groundwater

Numerical Simulation of the Developing Course of Piping

Experimental Study on Submerged Sand Erosion through a Slot on a Defective Pipe

Modelling lateral pipe-soil interaction on soft clay using large displacement sequential limit analysis

Simulation of Pipe Progression in A Levee Foundation with Coupled Seepage and Pipe Flow Domains

Numerical Simulation of Piping Based on Coupling Seepage and Pipe Flow

Numerical Simulation of Piping in Levee

Mechanism Study and Finite Element Simulation of Three-Phase Coupling Seepage Erosion Piping

A Three-Dimensional Numerical Method for Siphon Drainage Process Simulation

Modeling of Particle Migration in Piping Based on an Improved Discrete Element Method

The Research of 1D / 3D Coupling Simulation on Pump and Pipe System