Abstract:The modeling of stator and rotor faults is the basis of the development of online monitoring techniques. To obtain reliable stator and rotor fault models, this paper focuses on dynamic modeling of the stator and rotor faults in real-time, which adopts a multiple-coupled-circuit method by using a winding function approach for inductance calculation. Firstly, the model of the induction machine with a healthy cage is introduced, where a rotor mesh that consists of a few rotor loops and an end ring loop is considered. Then, the stator inter-turn fault model is presented by adding an extra branch with short circuit resistance on the fault part of a stator phase winding. The broken rotor bar fault is then detailed by merging and removing the broken-bar-related loops. Finally, the discrete models under healthy and faulty conditions are developed by using the Tustin transformation for digital implementation. Moreover, the stator and rotor mutual inductances are derived as a function of the rotor position according to the turn and winding functions distribution. Simulations and experiments are performed on a 2.2-kW/380-V/50-Hz three-phase and four-pole induction motor to show the performance of the stator and rotor faults, where the saturation effect is considered in simulations by exploiting the measurements of a no load test. The simulation results are in close agreement with the experimental results. Furthermore, magnitudes of the characteristic frequencies of 2f1 in torque and (1 ± 2s)f1 in current are analyzed to evaluate the stator and rotor fault severity. Both indicate that the stator fault severity is related to the short circuit resistance. Further, the number of shorted turns and the number of continuous broken bars determines the rotor fault severity.

Fault diagnosis methods for key sensors of doubly fed wind turbine

Stator Fault Detection Of Doubly-Fed Induction Generators Using Rotor Instantaneous Power Spectrum

Research on the Fault Diagnosis Method for Slip Ring Device in Doubly-Fed Induction Generators Based on Vibration

Model parameter identification of DFIG based on short circuit current

Finite-time fault detection and reconstruction of permanent magnet synchronous generation wind turbine via sliding mode observer

Modeling and Evaluation of Stator and Rotor Faults for Induction Motors

Fault Diagnosis of Inter-turn Short Circuit in Rotor Winding of Doubly-fed Generator Based on Data Fusion of Multi-flux Sensors

Fault Diagnosis in Wind Turbine Current Sensors: Detecting Single and Multiple Faults with the Extended Kalman Filter Bank Approach

Doubly Fed Induction Generator Wind Turbine Systems Subject to Recurring Symmetrical Grid Faults

A Control Strategy for Doubly-fed Induction Generator Wind Turbines under Asymmetrical Grid Voltage Conditions Caused by Faults

Online Identification Methodology of Field Winding Short Circuit Fault of Turbogenerator

Incipient Fault Detection and Condition Assessment in DFIGs Based on External Leakage Flux Sensing and Modified Multiscale Poincare Plots Analysis

Modeling Principle and Parameter Identification of Double Fed Wind Turbine for Electromechanical Transient Simulation of Power System

Research on Fault Diagnosis of Wind Turbine Based on WPA and RF

Multiscale Park's Vector Approach for Identifying Early Stator Fault Severity Using MCSA in DFIGs

Model of Stator Inter-Turn Short Circuit Fault in Doubly-Fed Induction Generators for Wind Turbine

Positioning Sensor-Less Control Method for Doubly Fed Induction Wind Power Generator

Using Flux Linkage Difference Vector in Early Inter-Turn Short Circuit Detection for the Windings of Offshore Wind DFIGs

Study on novel signal processing and simultaneous-fault diagnostic method for wind turbine

Current and flux correlation analysis for detection, location, and phase identification of stator inter-turn short-circuit fault in doubly-fed induction generator

Identification Of Multi-Concurrent Fault In A Steam Turbine Rotor System Using Model-Based Method