Abstract:The absence of artificial articular cartilage could cause the failure of artificial joints due to excessive material wear. There has been limited research on alternative materials for articular cartilage in joint prostheses, with few reducing the friction coefficient of artificial cartilage prostheses to the range of the natural cartilage friction coefficient (0.001-0.03). This work aimed to obtain and characterize mechanically and tribologically a new gel for potential application in articular replacement. Therefore, poly(hydroxyethyl methacrylate) (PHEMA)/glycerol synthetic gel was developed as a new type of artificial joint cartilage with a low friction coefficient, especially in calf serum. This glycerol material was developed via mixing HEMA and glycerin at a mass ratio of 1:1. The mechanical properties were studied, and it was found that the hardness of the synthetic gel was close to that of natural cartilage. The tribological performance of the synthetic gel was investigated using a reciprocating ball-on-plate rig. The ball samples were made of a cobalt-chromium-molybdenum (Co-Cr-Mo) alloy, and the plates were synthetic glycerol gel and two additional materials for comparison, which were ultra-high molecular polyethylene (UHMWPE) and 316L stainless steel. It was found that synthetic gel exhibited the lowest friction coefficient in both calf serum (0.018) and deionized water (0.039) compared to the other two conventional materials for knee prostheses. The surface roughness of the gel was found to be 4-5 μm through morphological analysis of wear. This newly proposed material provided a possible solution as a type of cartilage composite coating with hardness and tribological performance close to the nature of use in wear couples with artificial joints.

The Contrastive Study on Tribological Properties of Four Biopolymers Used for Articular Cartilage Repair

Analysis of friction between articular cartilage and polyvinyl alcohol hydrogel artificial cartilage

Tribological Properties of Polyvinyl Alcohol Hydrogel Reinforced with Nanometer Hydroxy Apatite

Tribological Property and Lubricant Mechanism of Biomimetic Artificial Cartilage Material

Construction and Tribological Properties of Biomimetic Cartilage-Lubricating Hydrogels

The factors of speeds and loads on the tribological properties of PVA-H/HA composites

Polyurethane as a potential knee hemiarthroplasty biomaterial: an in-vitro simulation of its tribological performance

The Effects of Surface Mechanical Deformation and Bovine Serum Albumin on the Tribological Properties of Polyvinyl Alcohol Hydrogel as an Artificial Cartilage

Study on the Wettability and Tribological Behavior of Different Polymers As Bearing Materials for Cervical Prosthesis

Comparison of wear on articular cartilage by titanium alloy, ultra-high-molecular-weight polyethylene, and carbon fibre reinforced polyether-ether-ketone: A pilot study

Preparation and biological performance of poly(vinyl alcohol)/hydroxyapatite porous composites used for cartilage repair

PVA-BA/PEG hydrogel with bilayer structure for biomimetic articular cartilage and investigation of its biotribological and mechanical properties

Tribological Characteristics of Polyvinylpyrrolidone (pvp) As A Lubrication Additive for Artificial Knee Joint

Mechanical and Biotribological Properties of PVA/SB Triple-Network Hydrogel for Biomimetic Artificial Cartilage

Improving the Mechanical Properties and Tribological Behavior of Sulfobetaine Polyurethane Based on Hydrophobic Chains to Be Applied as Artificial Meniscus

Study on Polyvinyl Alcohol Hydrogel Materials for Improving the Performance of Artificial Articular Cartilage

Comparison of the bio-tribological properties of UHMWPE-Chirulen® and PEEK-OPTIMA® articulating against ceramics: Implications for orthopedic implants

Biotribological properties of UHMWPE grafted with AA under lubrication as artificial joint

Study on the Friction and Wear Properties of PEEK Against Cortical Bone Tissue under Different Lubricating Conditions.

Investigation of the Friction Properties of a New Artificial Imitation Cartilage Material: PHEMA/Glycerol Gel

The Effect of Preparation Methods on Tribological Properties of PVA-H/HA Composites