Abstract:The existence of impuritiy phases such as Bi25FeO39 and Bi2Fe4O9 has led to high leakage current in BiFeO3 multiferric materials, which consequently restricts further understanding of its coupling between magnetic and polarization orders. Prior to the attempts to synthesize pure-phase BiFeO3 ceramics, the phase transition involved in the reaction sintering should be clarified. In the present, the phase transformations during the reaction sintering process of BiFeO3 ceramics with different molar ratio of Bi2O3/Fe2O3 in air were studied via High Temperature X-ray Diffraction technique (HT-XRD), Rietveld refinement quantification, and High Temperature Raman Spectroscopy (HT-Raman). The thermal stabilities of BiFeO3, Bi25FeO39 and Bi2Fe4O9 ceramics were also studied by such methods. The qualitative phase distributions after heating were analyzed by Electron Backscattered Diffraction (EBSD). Results show that the phase transition from monoclinic to cubic for Bi2O3 was well done, which usually taken place at 700 °C. The Fe2O3 did 1036 无机材料学报第 34 卷 not react with Bi2O3 to form BiFeO3 until that transition finished. In addition, BiFeO3, Bi25FeO39 and Bi2Fe4O9 phases are not in thermodynamic stable state during the cooling process for Bi excess samples. Bi2O3 excess can effectively inhibit the formation of impurities and promote the sintering of BiFeO3 phase. The phase content of BiFeO3 mainly depends on the molar ratio of Bi2O3/Fe2O3, and 1.03 : 1 is optimum. Combining with our previous research results, it is found that the effective parameters for the synthesis of BiFeO3 strongly depend on the excessive Bi and rapid heating and cooling rate. This work may provide useful experimental guidance for the preparation of pure-phase BiFeO3 ceramics.

Influence of Fe3+/Bi3+ on Preparation of Pure Phase BiFeO3 Films by Liquid Phase Self-Assembled Method and Study of Growth Mechanism

Preparation of BiFeO3 Thin Films by Chemical Solute Method

Ferroelectricity of the BiFeO3 prepared by the chemical solution deposition method

Photocatalytic And Magnetic Behaviors Of Bifeo3 Thin Films Deposited On Different Substrates

Effect of Substrates on the Structure and Optical Properties of Polycrystalline Bifeo3 Thin Films

Formation of Nano-Ag/Bifeo3 Composite Thin Film with Extraordinary High Dielectric and Effective Ferromagnetic Properties

Preparation and Characterization of BiFeO3 Powders by Sol-gel Method

Growth and Physical Properties of BiFeO3 Thin Films Directly on Si Substrate

Photocatalytic Property of Nanostructured Fe3+-Doped Bi2o3 Films

Adsorption-Controlled Molecular-Beam Epitaxial Growth Of Bifeo3

Chemical Co-Precipitation Synthesis and Properties of Pure-Phase BiFeO3

Stoichiometric Ratio on Phase Transformation in Reaction Sintering of BiFeO3 Ceramics Study: a High Temperature X-ray Diffraction Study

Effect of Substrates on Magnetization of Bifeo3 Films

Effects of substitution of Ti for Fe in BiFeO3 films prepared by sol–gel process

Synthesis and Photocatalytic Behaviors of High Surface Area Bifeo3 Thin Films

Co-Precipitation Synthesis of BiFeO<sub>3</sub> Powders

Ferroelectric Properties of BiFeO3 Films Grown by Sol–gel Process

Dielectric and optical properties of BiFeO 3-(Na 0.5Bi 0.5)TiO 3 thin films deposited on Si substrate using LaNiO 3 as buffer layer for photovoltaic devices

Effect of nitrating on the phase purification in BiFeO 3

Morphology and Orientation of Iron Oxide Precipitates in Epitaxial BiFeO3thin Films Grown under Two Non-Optimized Oxygen Pressures

Microstructural and Electrical Characteristics of Epitaxial Bifeo3 Thick Films Sputtered at Different Ar/O-2 Flow Ratios