Abstract:In order to effectively avoid the shoot-through issue of the semiconductor device (such as the power metal-oxide-semiconductor field-effect transistor (MOSFET)) adopted in the phase leg of the motor drives, a dead-time zone should be inserted. However, the nonlinearity caused by the dead-time effect will bring about voltage/current distortion, as well as high-order harmonics, which largely degrades the performance of motor drives, especially in low-speed operations with slight loads. In this paper, a dead-time compensation method is proposed to suppress such side effects caused by dead-time zones and improve the performance of motor drives. Compared with other existing methods, the proposed method is mainly focused on the switching characteristics of the power MOSFET, which is directly relative to the compensation time in each pulse-width modulation (PWM) period. Firstly, a detailed derivation process is elaborated to reveal the relationship between compensation time and the switching performance of the MOSFET. Meanwhile, the switching process of the MOSFET is also well analyzed, which summarizes the variations in the switching time of the MOSFET with a varied load current. Then, the multipulse test (MPT) is carried out to obtain accurate values of the switching time with the varied load current in a wide range (0–80 A) and form a 2D lookup table. As a result, the compensation method can easily be realized by combining the lookup table and linear interpolation based on the phase current of the motor dynamically. Finally, the effectiveness of the proposed method is verified based on a 12 V permanent magnet synchronous machine (PMSM) drive system. According to the relative experiment results, it can be clearly observed that the time-domain waveform distortion, high-order harmonics, and total harmonic distortion (THD) value are reduced significantly with the proposed dynamic compensation method.

Higher-order nonsingular terminal sliding mode dead-time compensation method in PMSM

Non-Singular Terminal Sliding Mode Control Of Inverter-Fed Pmsm System With Chattering Elimination

Improved 2-Order Active Disturbance Rejection Control for PMSM

Modeling and Compensation for Dead-Time Effect in High Power IGBT/IGCT Converters with SHE-PWM Modulation

Adaptive Robust Control of Inverter-Fed PMSM Servo System Using Continuous Sliding Mode

A Modified Deadbeat Predictive Current Control for Improving Dynamic Performance of PMSM

Integral Sliding Mode Control Based Deadbeat Predictive Current Control for PMSM Drives With Disturbance Rejection

Direct-axis Dead-time Effect Compensation Strategy Based on Adaptive Linear Neuron Method for PMSM Drives

Improved Non-Singular Fast Terminal Sliding Mode Control With Disturbance Observer for PMSM Drives

A Deadbeat Predictive Current Harmonics Suppression Method for IPMSM Based on Quasi Proportional Resonant Control

Dynamic Dead-Time Compensation Method Based on Switching Characteristics of the MOSFET for PMSM Drive System

An Improved Deadbeat Current Predictive Control with Active Disturbance Rejection for PMSM.

Dead‐time compensation for PMSM with phase shift of impedance considered based on adaptive linear neuron method

Adaptive backstepping hybrid terminal sliding-mode control for permanent magnet synchronous motor

A New Inverter Compensation Strategy Based On Adjusting Dead-Time On-Line

Enhanced Deadbeat Predictive Current Control for SPMSM Drives Combining Robust Super-Twisting Terminal Sliding Mode Speed Controller

Adaptive Deadbeat Predictive Current Control for PMSM with Feed Forward Method.

The compensated Active Disturbance Rejection Controller based on Sliding Mode Control for PMSM

New method of dead time compensation based on SVPWM strategy

Deadbeat Model-Predictive Torque Control With Discrete Space-Vector Modulation for PMSM Drives

Design and Implementation of Terminal Sliding Mode Control Method for PMSM Speed Regulation System