Abstract:To enhance the dynamic performance and disturbance rejection capability of the permanent magnet synchronous motor speed control system, a novel speed control method based on a novel sliding mode control (NSMC) and load torque observer is proposed on the basis of model predictive current control (MPCC) with a sliding mode disturbance observer. First, on the basis of MPCC, the influence of parameters such as resistance, inductance, and flux linkage on MPCC is analyzed. To address the aggregated disturbance caused by parameter mismatches, a piecewise square-root switching function sliding mode disturbance observer (SMDO) is designed to enhance the robustness of the parameters. To address the poor dynamic performance and inadequate robustness resulting from the proportional-integral-controller (PI) velocity loop control in the MPCC, a novel NSMC velocity control method is proposed. This method utilizes the hyperbolic sine function and fractional-order integral sliding mode surface, resolving the dilemma faced by traditional slide mode controllers (SMC) in balancing fast response and reduced vibration. Additionally, to enhance the system’s disturbance rejection capability, a sliding mode torque observer (SMTO) is designed to continuously update the observed load torque value into the NSMC controller, achieving speed compensation control. Finally, through comparative experiments among the proportional integral controller (PI), SMC, NSMC, and NSMC + SMTO, the results indicate that the proposed NSMC + SMTO exhibits the best speed response, steady-state characteristics, and disturbance rejection capability.

Enhanced Deadbeat Predictive Current Control for SPMSM Drives Combining Robust Super-Twisting Terminal Sliding Mode Speed Controller

A Modified Deadbeat Predictive Current Control for Improving Dynamic Performance of PMSM

A Combined Model Predictive Current Control for SPMSM Drive with Improved Robustness and Control Precision

Integral Sliding Mode Control Based Deadbeat Predictive Current Control for PMSM Drives With Disturbance Rejection

Improved Deadbeat Predictive Current Control Combined Adaptive Super-Twisting Algorithm Based Sliding-Mode Observer for Permanent-Magnet Synchronous Motors Drives

Improved Model Predictive Current Control for PMSM Drives Based on Dynamic Reference Current

A Modified Deadbeat Predictive Current Control with Improved Dynamic Performance under Insufficient Voltage Margin for IPMSM

Modified Deadbeat Predictive Current Control for PMSM Drive System Via a Composite Integral Sliding Mode Observer

Robust Deadbeat Predictive Direct Speed Control for PMSM with Dual Second-Order Sliding-Mode Disturbance Observers and Sensitivity Analysis

Improved Deadbeat Predictive Current Control with Extended State Observer for Dual Three-Phase PMSMs

Improved Deadbeat Predictive Current Control to Enhance the Performance of the Drive System of Permanent Magnet Synchronous Motors

Improved Deadbeat Predictive Current Control of PMSM Based on a Resistance Adaptive Position Observer

Robust Model Predictive Direct Speed Control for SPMSM Drives Based on Full Parameter Disturbances and Load Observer

An Enhanced Deadbeat Predictive Current Control of SPMSM with Linear Disturbance Observer

Sliding Mode Speed Control for PMSM Based on Model Predictive Current

A Deadbeat Digital Current Controller Based on Parallel Disturbance Rejection Structure for SPMSM

Model-Free Control Using Improved Smoothing Extended State Observer and Super-Twisting Nonlinear Sliding Mode Control for PMSM Drives

Dual Model Predictive Control Strategy of Direct‐Drive PMSM Based on Sliding Mode Disturbance Observer

Disturbance‐observer‐based speed control for SPMSM drives using modified super‐twisting algorithm and extended state observer

Robust Model Predictive Direct Speed Control for SPMSM Drives Based on Full Parameters and Load Observer

Deadbeat Predictive Current Control for SPMSM at Low Switching Frequency with Moving Horizon Estimator