Abstract:In order to effectively avoid the shoot-through issue of the semiconductor device (such as the power metal-oxide-semiconductor field-effect transistor (MOSFET)) adopted in the phase leg of the motor drives, a dead-time zone should be inserted. However, the nonlinearity caused by the dead-time effect will bring about voltage/current distortion, as well as high-order harmonics, which largely degrades the performance of motor drives, especially in low-speed operations with slight loads. In this paper, a dead-time compensation method is proposed to suppress such side effects caused by dead-time zones and improve the performance of motor drives. Compared with other existing methods, the proposed method is mainly focused on the switching characteristics of the power MOSFET, which is directly relative to the compensation time in each pulse-width modulation (PWM) period. Firstly, a detailed derivation process is elaborated to reveal the relationship between compensation time and the switching performance of the MOSFET. Meanwhile, the switching process of the MOSFET is also well analyzed, which summarizes the variations in the switching time of the MOSFET with a varied load current. Then, the multipulse test (MPT) is carried out to obtain accurate values of the switching time with the varied load current in a wide range (0–80 A) and form a 2D lookup table. As a result, the compensation method can easily be realized by combining the lookup table and linear interpolation based on the phase current of the motor dynamically. Finally, the effectiveness of the proposed method is verified based on a 12 V permanent magnet synchronous machine (PMSM) drive system. According to the relative experiment results, it can be clearly observed that the time-domain waveform distortion, high-order harmonics, and total harmonic distortion (THD) value are reduced significantly with the proposed dynamic compensation method.

Dead‐time compensation for PMSM with phase shift of impedance considered based on adaptive linear neuron method

An Enhanced Sensorless Control Scheme for PMSM Drives Considering Self-inductance Asymmetry

Hybrid Frame-Based Current Control Scheme for LC-Equipped PMSM with Non-Sinusoidal Back-EMF

Direct-axis Dead-time Effect Compensation Strategy Based on Adaptive Linear Neuron Method for PMSM Drives

Compensation of Current Measurement Error in PMSM Drives Based on Virtual Windings

Current Measurement Error Compensation Based on Modified Multiple Complex-Coefficient Filters in PMSM Drives

Dynamic Dead-Time Compensation Method Based on Switching Characteristics of the MOSFET for PMSM Drive System

Dead-Time Compensation Based on a Modified Multiple Complex Coefficient Filter for Permanent Magnet Synchronous Machine Drives

Dead time compensation of IPMSM based on neural network filter and current polarity detection

A Modified Deadbeat Predictive Current Control for Improving Dynamic Performance of PMSM

A new adaptive dead time compensation method for dual three-phase permanent magnet synchronous motor

Adaptive Torque Ripple Suppression Methods of Three-Phase PMSM During Single-Phase Open-Circuit Fault-Tolerant Operation

A Deadbeat Predictive Current Harmonics Suppression Method for IPMSM Based on Quasi Proportional Resonant Control

Model Predictive Current Control with Adaptive-Adjusting Timescales for PMSMs

Dead-Time Compensation Using ADALINE for Reduced-Order Observer-Based Sensorless SynRM Drives

Analysis and Compensation of Sampling-Delay Error in Single Current Sensor Method for PMSM Drives

Higher-order nonsingular terminal sliding mode dead-time compensation method in PMSM

Adaptive Deadbeat Predictive Current Control for PMSM with Feed Forward Method.

ADALINE Network Based PLL for Position Sensorless Interior Permanent Magnet Synchronous Motor Drives

Deadbeat Predictive Current Control for SPMSM at Low Switching Frequency with Moving Horizon Estimator

Improved Deadbeat Predictive Current Control Strategy for Permanent Magnet Motor Drives