Abstract:Recently, flat heat pipes have been proposed for surface cooling applications to passively extract and recover thermal energy from hot surfaces. For instance, flat heat pipes have recently been proposed as thermal absorber for photovoltaic/thermal (PV/T) applications or for the thermal management of batteries. Following promising surface cooling results, increasing the fundamental knowledge of the two-phase heat transfer taking place inside such multi-channel flat heat pipes can participate to its widespread and lead to further improvement of the technology. Indeed, until now, the investigations have focused on the application only and not on the performance of the flat heat pipe itself. In this regard, this manuscript experimentally and theoretically investigates the thermal performance of a multi-channel flat heat pipe used for surface cooling applications. Heat transfer rates in the range 0–1500 W are studied and their impact on the boiling, condensation, and total thermal resistance of the multi-channel flat heat pipe is measured. In order to predict the thermal performance of the multi-channel flat heat pipe at all heat transfer rates, a theoretical model is proposed, which considers the impact of the multi-channel geometry. This model uses a multi-channel thermal resistance network. Furthermore, an important number of two-phase correlations for pool boiling and condensation are compared with experimental data and the optimum equations are integrated into the multi-channel model. As a result, over the whole range of heat transfer rates investigated, the proposed multi-channel flat heat pipe model was able to predict the boiling, condensation, and total thermal resistances of the heat pipe with an average error of 17.2%, 14.4% and 13.1%, respectively. Finally, the impact of the tilt angle is also studied, and infrared imaging of the flat heat pipe surface is presented.

An experimental study of flat plate heat pipe with interlaced micro grooves

Experimental Studies on a Novel Thin Flat Heat Pipe Heat Spreader

Experimental Study on New Flat Plate Solar Water Heater

Design and Experimental Analysis of Grooved Flat Aluminum Heat Pipe

Visualization Study on the Enhancement of Heat Transfer for the Groove Flat-Plate Heat Pipe with Nanoflower Coated CuO Layer

Status and Recent Progress of Research on Flat Plate Heat Pipes

Experimental and simulation study on flow heat transfer characteristics of flat pulsating heat pipe with wide and narrow interphase channels

Experimental investigation on thermal characteristics of flat miniature axially grooved heat pipes

Design and Research of Flat Micro Heat Pipe with Glass Fiber Wick

Analysis on Heat Resistance of the Micro Heat Pipe with Arteries

Experimental investigation of flow visualization and thermal performance of flat-plate single-loop pulsating heat pipes

THE EXPERIMENTAL INVESTIGATION OF PHASE CHANGE HEAT TRANSFER IN A FLAT PLATE HEAT PIPE

Heat Transfer Capacity Optimization Design of Microgroove and Microcolumn in an Ultra-Thin Flat Heat Pipe

Design, Simulation and Fabrication of A Silicon Micro Flat Heat Pipe with Axial Triangle Grooves

Experimental Investigation of Thermal Conduction Performance on Silicon-Based Micro Flat Heat Pipe

Visualization research on influencing factors of flat heat pipes

Experimental Study on Thermal Performance of a Novel Serpentine-Looped Flat Microchannel Heat Pipe

Experimental and theoretical investigation of the influence of heat transfer rate on the thermal performance of a multi-channel flat heat pipe

Theoretical Analysis of Flat Heat Pipe with Graded-Porosity Wick Design

Design and Fabrication of Flat Heat Pipes with Different Length

Characteristics of a Micro Flat Heat Pipe with Trapezoidal Grooves