Abstract:Background: Conventional methods of preparing magnetoliposomes are complicated and inefficient. A novel approach for magnetoliposomes preparation was investigated in the study reported here.Methods: FeCl3/FeCl2 solutions were hydrated with lipid films to obtain liposome-encapsulated iron ions by ultrasonic dispersion. Non-encapsulated iron ions were removed by dialysis. NH3 center dot H2O was added to the system to adjust the pH to a critical value. Four different systems were prepared. Each was incubated at a different temperature for a different length of time to facilitate the permeation of NH3 center dot H2O into the inner phase of the liposomes and the in situ formation of magnetic iron-oxide cores in the liposomes. Single-factor analysis and orthogonal-design experiments were applied to determinate the effects of alkalization pH, temperature, duration, and initial Fe concentration on encapsulation efficiency and drug loading.Results: The magnetoliposomes prepared by in situ precipitation had an average particle size of 168+/-14 nm, zeta potential of -26.2+/-1.9 mV and polydispersity index of 0.23+/-0.06. The iron-oxide cores were confirmed as Fe3O4 by X-ray diffraction and demonstrated a superparamagnetic response. Encapsulation efficiency ranged from 3% to 22%, while drug loading ranged from 0.2 to 1.58 mol Fe/mol lipid. The optimal conditions for in situ precipitation were found to be an alkalization pH of 12, temperature of 60 degrees C, time of 60 minutes, and initial Fe concentration of 100 mM Fe3+ + 50 mM Fe2+.Conclusion: In situ precipitation could be a simple and efficient approach for the preparation of iron-oxide magnetoliposomes.

Selection of Preparation Conditions of Fe3O4 Magnetic Nanoparticles Based on Orthogonal Method

Polyol Synthesis of Superparamagnetic Fe_3O_4 Nanoparticles for Magnetic Resonance Imaging

Influence of Different Preparation Methods on Crystallisation and Morphology of Fe2o3 Nanoparticles

Analysis of the Factors Affecting the Magnetic Characteristics of Nano-Fe 3 O 4 Particles

Solvothermal Synthesis and Magnetic Property of Monodispersed Fe_3O_4 Nano-powders

Preparation and characterization of Fe3O4 nanoparticles via a hydrothermal process with propanediol as the solvent

Preparation and Surface Modification of Monodisperse Fe3O4 Nanoparticles

Synthesis and characterization of nano-sized magnetic ferroferric oxide particles

Synthesis of Monodispersed Fe3O4 Magnetite Nanoparticles by ethylene glycol solvothermal method

Preparation, Surface Functionalization and Application of Fe3O4 Magnetic Nanoparticles

Preparation and Characterization of the Novel Magnetic Nano-Sized Ferrite(Fe_3O_4) Particles Modified by C_(16)H_(33)NaO_2

In Situ Precipitation: a Novel Approach for Preparation of Iron-Oxide Magnetoliposomes.

Preparation and Characterization of Ω-Functionalized Polystyrene–magnetite Nanocomposites

Preparation and Surface Modification of Fe<sub>3</sub>O<sub>4 &Lt;/sub>nano-Magnetic Powders

Ferromagnetic Fe3O4 Nanofibers: Electrospinning Synthesis and Characterization

Stability and magnetization of Fe3O4/water nanofluid preparation characteristics using Taguchi method

Research on the Preparation and Characterization of Magnetic Nanoparticles (mnps) by Chemical Co-precipitation

Preparation of High Magnetic Fe_3O_4/TiO_2 Composite Particles

Preparation and Characterization of Fe<sub>3</sub>O<sub>4</sub>@Au Nanoparticles Used As Precursor of Ferrofluids

Preparation And Characterization Of Fe(3)O(4)@Au Nanoparticles Used As Precursor Of Ferrofluids

A Simple Solution Route to Control Synthesis of Fe3O4 Nanomaterials at Low Temperature and Their Magnetic Properties