Abstract:Bounding surface plasticity has been widely used for capturing the stress–strain behaviour of geomaterials. However, it may require multiple sets of model parameters for constitutive modelling of sands with a wide range of initial states, because of the distinct critical state characteristics under low and high densities or pressures in the <span class="mathjax-tex">\(e-\ln {p}'\)</span> plane. In this study, an enhanced bounding surface plasticity approach for sand with a wide range of initial material states is developed. A fractional plastic flow rule and a modified critical state line are suggested, which ensures that without using any predefined state indices, the developed model can consider the state-dependent dilatancy and hardening behaviours of sand subjected to low and high pressures/densities. The approach is validated by simulating the well-documented test results of Toyoura sand and Sacramento River sand. For comparison, the original state-dependent dilatancy approach in Li and Dafalias (Géotechnique 50(4):449–460, 2000. <a href="https://doi.org/10.1680/geot.2000.50.4.449">https://doi.org/10.1680/geot.2000.50.4.449</a>) is also adopted and implemented. It is found that the two approaches can reasonably capture the typical stress–strain behaviour, e.g. hardening/contraction, softening/dilation, liquefaction, quasi-steady state flow, and non-flow, of sands with different initial material states, by using a single set of model parameters. However, compared to the current work, Li and Dafalias (2000) model relied on a predefined state parameter, for capturing the state-dependent behaviour of sand under a wide range of initial states

Improved Lade-Duncan Model Based on SMP Criterion

AN ELASTOPLASTIC MODEL FOR SAND CONSIDERING DISTURBANCE

Hypoplastic Model for Sand under Multidirectional Shearing Conditions Considering Fabric Change Effect

MPM Modeling of Pile Installation in Sand: Contact Improvement and Quantitative Analysis

Large Deformation Analysis of Intermittent Pile Penetration into Dense Sand Incorporating a State Dependent Mohr–Coulomb Model

Non-coaxial hypoplastic model for sand with evolving fabric anisotropy including non-proportional loading

Hypoplastic Modeling of Anisotropic Sand Behavior Accounting for Rotation of Principal Stress Direction

Modified Duncan-Chang Model Considering Physical Properties of Saturated Clays

A rotational plastic potential model and non-associated plastic flow rule

Unified Modeling of the Influence of Consolidation Conditions on Monotonic Soil Response Considering Fabric Evolution

Modified Duncan-Chang model considering disturbance

Micromechanics-based multimechanism bounding surface model for sands

A refined deviatoric hardening plastic model for sand

Three-dimensional multi-mechanism bounding surface model for sands

Bounding surface plasticity for sand using fractional flow rule and modified critical state line

A Unified Plasticity Model for Large Post-Liquefaction Shear Deformation of Sand

Three‐dimensional Anisotropic Plasticity Model for Sand Subjected to Principal Stress Value Change and Axes Rotation

A unified monotonic model for sand based on modified hyperbolic equation and state-dependent dilatancy

A thermodynamic critical state model for sands

A coupled elasto-plastic damage model for fine-grained sandstone under triaxial compression and lateral extension loading conditions

Non-linear Constitutive Model for Geomaterials under Complicated Stress State