Abstract:Tensile, compressive, cyclic tension-tension, and cyclic compression-compression tests at room temperature were systematically applied to a Zr52.5Cu17.9Al10Ni14.6Ti5 bulk metallic glass for comprehensive understanding of its damage and fracture mechanisms. Under tensile loading, the metallic glass only displays elastic deformation followed by brittle shear fracture. Under compressive loading, after elastic deformation, obvious plasticity (0.5 to 0.8 pct) can be observed before the final shear fracture. The fracture strength under compression is slightly higher than that under tension. The shear fracture under compression and tension does not occur along the maximum shear stress plane. This indicates that the fracture behavior of the metallic glass does not follow the Tresca criterion. The fracture surfaces show remarkably different features, i.e., a uniform vein structure (compressive fracture) and round cores coexisting with the radiating veins (tensile fracture). Under cyclic tension-tension loading, fatigue cracks are first initiated along localized shear bands on the specimen surface, then propagated along a plane basically perpendicular to the stress axis. A surface damage layer exists under cyclic compression-compression loading. However, the final failure also exhibits a pure shear fracture feature as under uniaxial compression. The cyclic compression-compression fatigue life of the metallic glass is about a factor of 10 higher than the cyclic tension-tension fatigue life at the same stress ratio. Based on these results, the damage and fracture mechanisms of the metallic glass induced by uniaxial and cyclic loading are elucidated.

Morphology of fracture surface of a copper-base massive glass-forming alloy

Stress-life fatigue behavior and fracture-surface morphology of a Cu-based bulk-metallic glass

Microstructure evolution and mechanical properties of Cu46Zr47Al7 bulk metallic glass composite containing CuZr crystallizing phases

Compressive fracture morphology and mechanism of metallic glass

Tensile fracture morphologies of bulk metallic glass

Ductile Fracture of Bulk Metallic Glass Zr 50 Cu 40 Al 10 under High Strain-Rate Loading

Fatigue and fracture behavior of bulk metallic glass

Failure behavior of Cu–Ti–Zr-based bulk metallic glass alloys

Microstructure and Fracture Behavior of Zr55Cu30Al10Ni5 Bulk Metallic Glass and Its Composites Containing ZrO2

Microstructural heterogeneities governing the deformation of Cu47.5Zr47.5Al5 bulk metallic glass composites

Modeling Deformation Behavior Of Cu-Zr-Al Bulk Metallic Glass Matrix Composites

Tension Fracture Behavior of Zr41.25ti13.75ni10cu12.5be22.5 Bulk Metallic Glass

Effect of Microstructures on the Compressive Deformation and Fracture Behaviors of Zr47Cu46Al7 Bulk Metallic Glass Composites

Some Aspects of the Fracture Behaviour of Mg65cu25y10 Bulk Metallic Glass During Room-Temperature Bending

Compressive Fracture Behavior of Cu-Based Bulk Amorphous Alloys

Homogeneous plastic deformation in a Cu-based bulk amorphous alloy

Formation and mechanical properties of bulk Cu-Ti-Zr-Ni metallic glasses with high glass forming ability

Formation and mechanical properties of Cu_(58)Zr_(20)Ti_(20)Mo_2 bulk metallic glass

Compressive Fracture Characteristics of A Zr-Based Bulk Metallic Glass at High Test Temperatures

Damage Morphology Study of High Cycle Fatigued As-Cast Mg–3.0Nd–0.2Zn–Zr (wt.%) Alloy

Strain-Field Evolution in A Cuzr-Based Bulk Metallic Glass Composite During Tensile Deformation