Abstract:Severe tool wear is always considered as a main negative result in the process of drilling Ti-6Al-4V alloy. Although the idea of employing one-dimensional longitudinal ultrasonic vibration in the drilling process to reduce tool wear has been proposed for many years, studies on longitudinal-torsional composite ultrasonic vibration–assisted drilling (LT-UAD) are seldom reported. LT-UAD is a hybrid machining process in which high-frequency and low-amplitude vibrations are superimposed simultaneously on the rotational direction and the axial direction of the drilling bit respectively. In this study, a hollow vibration converter with thread grooves is presented for LT-UAD purpose. Based on an in-depth kinematic analysis, a condition for separating the tool from the workpiece is derived, indicating that a lower feed rate, a lower spindle speed, and a higher amplitude are more advantageous. Machining experiments are performed, wherein good agreement is found between the experimental and theoretical results. The results show that LT-UAD has obvious advantages over longitudinal ultrasonic vibration–assisted drilling and conventional drilling in reducing tool wear. Additionally, the influences of the vibration amplitude, spindle speed, and feed rate on the flank wear width are analyzed, revealing the influences of the three factors in descending order are feed rate, amplitude, and spindle speed. The optimum machining parameters are obtained as 23 μm of amplitude, 385 r/min of spindle speed, and 0.06 mm/r of feed rate. Furthermore, a reliable regression model of flank wear width is established based on response surface methodology. With this prediction model, the flank wear width of drill bit under different machining parameters can be accurately predicted.

Study on A Novel Adaptive Force Control Table Employed for Rotary Ultrasonic Drilling

Design of a Novel Air Bearing Workbench for Rotary Ultrasonic Drilling of Advanced Ceramics

Modeling of Non-Linear Cutting Forces for Dry Orbital Drilling Process Based on Undeformed Chip Geometry

Air-Lubricated Pneumatic Workbench

Countersink depth control of robot drilling based on pressure foot displacement compensation

Research on Control Method for Machining Non-Cylinder Pin Hole of Piston

Dynamic Cutting Force Modeling and Experimental Study of Industrial Robotic Boring

Development of a Force Controlled Nanocutting System Using a Flexible Mechanism for Adaptive Cutting of Microstructures on Non-Planar Surfaces

Experimental and Theoretical Investigation on Critical Cutting Force in Rotary Ultrasonic Drilling of Brittle Materials and Composites

Design and Adaptive Terminal Sliding Mode Control of a Fast Tool Servo System for Diamond Machining of Freeform Surfaces

Adaptive Control in Pinhole Drilling

Micro-Drilling Process Control by Using Adaptive Sliding Controller

Investigation of force modeling in ultrasonic vibration-assisted drilling SiC f /SiC ceramic matrix composites

Study on tool wear in longitudinal-torsional composite ultrasonic vibration–assisted drilling of Ti-6Al-4V alloy

Research on Variable Parameter Drilling Method of Ti-CFRP-Ti Laminated Stacks Based on Real-Time Sensing of Drilling Axial Force

Study on Ultrasonic Driller for Microstructure Manufacture

Cutting Performance Optimization and Experimental Research of Indexable Insert Drill

Study on the Simulation and Experiment of Ultrasonic-assisted Vibration Drilling of Ti6Al4V

Experiments on Machining Micro-Hole and Cutting Tool Failure Mechanism

Influence of Longitudinal-Torsional Ultrasonic-Assisted Vibration on Micro-Hole Drilling Ti-6Al-4V