Some Fundamental Problems Concerning the Measurement Accuracy of the Hopkinson Tension Bar Technique
Yinggang Miao,Bing Du,Chenbo Ma,Haitao Hu,Qiong Deng
DOI: https://doi.org/10.1088/1361-6501/ab01b5
2019-01-01
Abstract:The Hopkinson tension bar technique is widely used and is the only method utilized to measure the mechanical behaviors of materials under a high strain rate; however, many fundamental problems still exist that need to be made clear, which directly link to measurement accuracy. In this work, these problems are elaborately investigated theoretically and experimentally, with the aid of a novelly designed integrated Hopkinson tension bar. Firstly, the calibration for the dynamical mechanical parameters of the bar is theoretically proposed and experimentally obtained by the one-dimension stress wave method, and verified by the integrated Hopkinson tension bar. Then, the stress wave theory is introduced to reconstruct the initial loading process of the Hopkinson bar technique for quantitatively assessing the stress inequilibrium influence on measurement accuracy at small strain. The results indicate that the elastic modulus under high strain rate loading can be determined using the Hopkinson tension bar technique, for the influence of stress inequilibrium is little even when the loading time is over 2.2 characteristic times. The traditional dynamic tension specimens are fixed to the bar ends by gluing plate specimens and screwing the screwed dogbone specimen. The joint contacts are assessed experimentally and analyzed with the integrated Hopkinson tension bar as a reference, as it requires a perfect contacting condition from the specimen to the bar ends. Finally, the involved influences are also explained to elucidate the intrinsic factors, in the hope of offering some reference for potential experiments. Comparison investigations are also conducted with the aim of simulation work, and it is found that the measurement accuracy is distinctly influenced by the transition zone, whereas the influence can be compensated by selecting a specimen with a gauge length around double that of the diametric size.