Abstract:Modal parameters are inherent characteristics of civil structures. Due to the effect of environmental factors and ambient loads, the physical and modal characteristics of a structure tend to change over time. Therefore, the effective identification of time-varying modal parameters has become an essential topic. In this study, an instantaneous modal identification method based on an adaptive chirp mode decomposition (ACMD) technique was proposed. The ACMD technique is highly adaptable and can accurately estimate the instantaneous frequencies of a structure. However, it is important to highlight that an initial frequency value must be selected beforehand in ACMD. If the initial frequency is set incorrectly, the resulting instantaneous frequencies may lack accuracy. To address the aforementioned problem, the Welch power spectrum was initially developed to extract a high-resolution time–frequency distribution from the measured signals. Subsequently, the time–frequency ridge was identified based on the maximum energy position in the time–frequency distribution plot, with the frequencies associated with the time–frequency ridge serving as the initial frequencies. Based on the initial frequencies, the measured signals with multiple degrees of freedom could be decomposed into individual time-varying components with a single degree of freedom. Following that, the instantaneous frequencies of each time-varying component could be calculated directly. Subsequently, a sliding window principal component analysis (PCA) method was introduced to derive instantaneous mode shapes. Finally, vibration data collected under various operational scenarios were used to validate the proposed method. The results demonstrated the effective identification of time-varying modal parameters in real-world civil structures, without missing modes.

Structural Modal Analysis Based on HHT and Butterworth Filter

A Multi-Task Learning-Based Automatic Blind Identification Procedure for Operational Modal Analysis

DEEP LEARNING-BASED AUTOMATIC BLIND IDENTIFICATION PROCEDURE FOR STRUCTURAL MODAL IDENTIFICATION

Improvement of H HT in Structural Modal Parameter Identification

Study on the Method of EMD-Based Vibration Signal Time-Frequency Analysis

The HHT-based Analysis of Rotor Running Across Critical Rotating

Operational Modal Analysis of Civil Engineering Structures with Closely Spaced Modes Based on Improved Hilbert–Huang Transform

EMD Method on Identifying Natural Frequency and Damping Ratio of Vibration Mode

Improvements in the HHT for the Modal Parameter Identification of Structures with Closely Spaced Modes

Modal parameter identification for engineering structures based on HHT method

HHT method for system identification and damage detection: an experimental study

Discrete analytical mode decomposition with automatic bisecting frequency selection for structural dynamic response analysis and modal identification

IDENTIFICATION OF STRUCTURAL MODAL PARAMETERS WITH WAVELET TRANSFORMATION

Non-stationary signal decomposition approach for harmonic responses detection in operational modal analysis

Structural modal identification and MCMC-based model updating by a Bayesian approach

Modal Parameters Identification of Time-Varying System Based on Hilbert-Huang Transform

High-resolution frequency domain decomposition for modal analysis of bridges using train-induced free-vibrations

Modal Identification of Multi-Degree-of-freedom Structures Based on Intrinsic Chirp Component Decomposition Method

Damping identification using weighted fitting of Frequency-response-function (WFF) method

An Adaptive Chirp Mode Decomposition-Based Method for Modal Identification of Time-Varying Structures

HHT-based Structural Damage Identification for Transmission Tower