Abstract:Mechanical properties of high density polyethylene (HDPE) solid-state drawn with fixed draw ratio at different temperatures in a fiber/tape spin line were investigated. All drawing experiments were performed in the pseudo-affine regime, i.e. no effective relaxation of the molecules occurs during drawing. For such conditions, the Young's modulus is uniquely determined by the applied draw ratio. The general appearance of the stress–strain behavior of drawn HDPE, and in particular its yield strength, however, is strongly influenced by the stretching temperature applied. For a fixed draw ratio, a significant drop in yield stress can be observed with decreasing drawing temperature. Characterization of structure and organization of the solid-state drawn HDPE was performed using various analytical techniques, such as wide-angle X-ray diffraction (WAXD) and differential scanning calorimetry (DSC). It is proposed that solid-state drawing at temperatures above the α-relaxation temperature results in relative large crystals so that corresponding tapes show a high yield point. Drawing at low temperatures below the α-relaxation temperature of PE, however, causes formation of small or imperfect crystals that can be destructed at low stress (low yield point), which is a preferable start situation for a second solid-state drawing step in a multiple drawing process.

Measurement of extensional rheological properties of HDPE by melt spinning techniques

Study on Extensional Rheological Behavior of Polyethylene Using Melt Spinning Techniques

Study on extensional rheological properties of LDPE using melt spinning technique

Elongational Rheology of Lldpe by Melt Spinning Technique

Extensional rheology of LDPE from melt spinning technique

Elongation properties of polyethylene melts

Elongational Properties of Low Density Polyethylene Using Melt Spinning Technique

Melt Spinning Flow Behaviour of High-Density Polyethylene Blended with Low-Density Polyethylene

An Analysis of Melt Spinning Master-Curves of Low-Density Polyethylene/linear Low-Density Polyethylene Blends

Melt Elongation Properties of Linear Low-Density Polyethylene

Melt Elongation Flow Behaviour of LDPE/LLDPE Blends

Estimation of Elongation Viscosity of Polyethylene Melts

Melt Strength and Drawability of HDPE, LDPE and HDPE/LDPE Blends

Effects of Extrusion Conditions on Melt Viscoelasticity During Capillary Flow of Low-Density Polyethylene

Melt Flow Properties During Capillary Extrusion of Linear Low-Density Polyethylene

Tensile Properties and Condensed Structure of Vibration Extruded HDPE Blends

Characteristics of melt shear viscosity during extrusion of polymers

Measurement and Analysis on Tensile Strength and Crystallinity of Vibrating Extruded High-Density Polyethylene(Hdpe) Sheet

The influence of drawing temperature on mechanical properties and organization of melt spun polyethylene solid-state drawn in the pseudo-affine regime

Analysis on Melt Spinning Mastercurves of Polyethylene

Melt Elongation Strength and Drawability of LDPE/LLDPE Blends