Abstract:The proton exchange membrane fuel cell (PEMFC) stack is made of multiple single cells. Its working life is subject to the performance of the worst cell, which is an obvious short-board effect. Therefore, improving the voltage uniformity is the key factor to improve the working life of the stack. This research determines that during dynamic loading and reduction with sufficient reaction gas, the PEMFC stack will experience a voltage difference of single cell for about 100 ms, which is even more than 100 mV. This phenomenon cannot be observed by the total voltage variation curves of the stack or voltage monitor curve of the single cell with the scan period of seconds. Through theoretical analysis, this paper reveals that the great distribution uncertainty of liquid water in the diffusion layer causes the difference of diffusion coefficients of each single cell. Subsequently, in the fast dynamic response process, oxygen concentrations between the surfaces of the catalysts differ greatly, resulting in the non-uniformity of transient voltage. The voltage difference will disappear again after finishing the dynamic change process, and a new steady process is established. Further experiments indicate that monomer voltage uniformity changes with the current step amplitude and current variation frequency in the dynamic process of variable load. By adjusting the two parameters, we can effectively ensure that the single cell voltage is in uniform change state. This paper reports that substantial non-uniformity exists within a short time during the variable load process of the PEMFC stack. The reason for this phenomenon is also interpreted. A controlling method is also carried out for inhibiting the non-uniformity, which will open a new perspective for controlling the fuel cell stack during the dynamic process of variable load.. Copyright (C) 2015, Hydrogen Energy Publications, LLC. Published by Elsevier Ltd. All rights reserved.

On Flow Maldistribution In Pemfc Stacks

A Model Reduction Framework of Flow Maldistribution and Mitigation Strategy for Parallel Flow Field Based Polymer Exchange Membrane Fuel Cell

Analysis and improvement of flow distribution in manifold for proton exchange membrane fuel cell stacks

Effects of Flow Field on Thermal Management in Proton Exchange Membrane Fuel Cell Stacks: A Numerical Study

Entrance Effects on the Flow Distribution in Manifold of Commercial-Size Proton Exchange Membrane Fuel Cell Stacks

Analyzing and Optimizing Cathode Gas Distribution Uniformity in Proton Exchange Membrane Fuel Cell Stacks Based on Two-Phase Flow Network Model

A review: Fluid dynamic and mass transport behaviour in a proton exchange membrane fuel cell stack

Investigating the Effect of the Compensation Flow Fields on the Performance and Thermal Stress Distribution of a Typical Fuel Cell

Study on the Effects of Manifold Structure on the Gas Flow Distribution Uniformity of Anode of PEMFC Stack with 140-Cell

A Method to Study the Intake Consistency of the Dual-Stack Polymer Electrolyte Membrane Fuel Cell System under Dynamic Operating Conditions

Study on the Heat and Mass Transfer Mechanisms of Liquid-Cooled PEMFC Stacks Based on Non-Isothermal Model

Analytical and numerical investigation of flow distribution in PEMFC stacks

Experimental Study on the Voltage Uniformity for Dynamic Loading of a PEM Fuel Cell Stack

Behavior of a Single Direct Methanol Fuel Cell in Stacks at Air Maldistribution Conditions

Numerical Analysis of Parallel Flow Fields Improved by Micro-Distributor in Proton Exchange Membrane Fuel Cells

Manifold Design in a PEM Fuel Cell Stack to Improve Flow Distribution Uniformity

An Experimental Method to Measure Flow Distribution in the Cathode of High‐Temperature Polymer Electrolyte Membrane Fuel Cells Stack

A comprehensive investigation on performance heterogeneity of commercial-size fuel cell stacks during dynamics operation

Numerical Study on Effect of Flow Field Configuration on Air-Breathing Proton Exchange Membrane Fuel Stacks

Review of Flow Field Designs for Polymer Electrolyte Membrane Fuel Cells

Manifold geometry optimization and flow distribution analysis in commercial-scale proton exchange membrane fuel cell stacks