Abstract:The double-K fracture model can well describe the development of cracks undergoing during the entire fracture process in concrete. Therefore, it has been selected as the theoretical basis of the “Norm for fracture test of hydraulic concrete” (China) and the double-K fracture parameters proposed in this model are regarded as the essential fracture parameters needed to be measured. Therefore, the primary objection of this paper is to present an overall report on the determination of the double-K fracture parameters of concrete involving the fundamental theory, calculation formulas, experimental arrangement and identification of initial cracking load in order to provide a reference for the specification committee. The fracture tests are carried out on the total of 43 concrete specimens where the small-size aggregates with the maximum size of 10 mm are chosen. Two typical widely-used geometries, i.e. three-points bending beam and wedge splitting specimen are adopted. The initial cracking load is determined by means of graph method or electrical resistance strain gauge method. Then, the initial fracture toughness and unstable fracture toughness are measured. It is found that the ratio of initial cracking load to maximum load is 0.67–0.71 and the ratio of initial fracture toughness to unstable fracture toughness is 0.45–0.50. It is also found that, for the initial fracture toughness and unstable fracture toughness, the values are approximately close to the constants when the depth of specimens is large than 200 and 400 mm for three-points bending beams and wedge splitting specimens respectively. Besides, the critical crack tip opening displacement of each specimen is calculated, too. The big difference between two geometries is noticed.

Study on Initial Cracking Criterion for Ⅰ-Ⅱ Mixed Mode Crack and Influence of Crack-Depth Ratio in Concrete by Using Four-Point Shearing Beams

Shear Tests of Reinforced Concrete Beams with the Influence of Initial Shear Cracks

INCORPORATING PRE-EXISTING CRACKS IN STRUCTURAL ASSESSMENT OF RC STRUCTURES

Experimental study on Ⅰ-Ⅱ mixed mode fracture performance and influence of crack-depth of self-compacting rock-filled concrete

Numerical simulation of cracking of early-age concrete three-point beams

The Influence of Span/Depth Ratio on the Double-K Fracture Parameters of Concrete

Experimental Study on Some Factors Affecting Fracture Property of Concrete

Numerical Analysis for Crack Width of Reinforced Concrete Beam with Bond-Slip Effect

Influence of Specimen Initial Crack Length on Double-K Fracture Parameter of Concrete

Influence of Mineral Admixture on Early-Age Concrete Cracking

Mechanical properties and numerical simulation of crack interface in reinforced concrete

Experimental Investigation on Criterion of Three-Dimensional Mixed-Mode Fracture for Concrete

New concrete cracking model established based on fracture mechanics and damage theory

Calculation Method and Experimental Research for Crack Width in RC Single Column Piers

Determination of double- K criterion for crack propagation in quasi-brittle fracture, Part II: Analytical evaluating and practical measuring methods for three-point bending notched beams

Evaluation of criteria of I-II mixed crack angles

Three-dimensional numerical study on mode-I local crack propagation of concrete considering boundary effect

A new test method for the complete load-displacement curve of concrete under mixed mode I-II fracture

Experimental measurement of double-K fracture parameters of concrete with small-size aggregates

DETERMINATION OF CRACK INITIATION AND EQUIVALENT CRACK LENGTH OF LOW STRENGTH CONCRETE USING STRAIN GAUGES