Abstract:A low‐carbon (0.23 wt%) carbide‐free bainitic steel is successfully developed with a total alloying addition of 4.9 wt%, which is relatively lower than alloying additions reported in similar category of steels. The present findings indicate that the currently designed low‐alloy steel composition is amenable to generation of nearly carbide‐free bainitic microstructure in large‐sized components under normal cooling conditions. Microstructures of steel after a,b) water quenching, c,d) air cooling, and e,f) furnace cooling, where bainite is obtained in both air and furnace cooled conditions. Bainitic microstructures in high‐strength steels are obtained either by continuous cooling or isothermal holding. Both scenarios necessitate faster cooling to keep the parent austenite phase untransformed till the bainite‐start temperature. The present study reports the development of bainitic microstructure in a low‐carbon steel with minimal alloying additions, under continuous cooling at very slow rates, similar to furnace cooling. For understanding the related transformation pathways, samples from the forged‐steel ingot are austenitized and cooled at different rates, viz. water quenching, air cooling, and furnace cooling. Microstructural characterization reveals development of acicular microstructures in all samples including the forged one, with gross absence of carbides. X‐ray diffraction confirms the ferritic nature of acicular plates and also indicated retained austenite present in some samples, the content of which could be correlated to the extent of bainitic transformation. Thermodynamic calculations together with microstructural observations (e.g., ferrite plate size) and hardness data established the development of fully martensitic microstructure on water quenching, while that of a mixed microstructure comprising predominantly of bainite in the forged, air cooled, and furnace‐cooled condition. The aforementioned findings could have wider implications in developing fully bainitic microstructures in large components, where uniform rapid cooling is not practically feasible.

Preparation and Microstructure of Hard Bainite in Surface Layer of Carburized 20crmnmoal Steel

Preparation and microstructural characterization of hard bainite in surface layer of low-carbon alloy steel

Ultrafine Bainite in the Surface Layer of 38CrMoAl Steel

Preparation and Microstructure Characteristics of Low-Temperature Bainite in Surface Layer of Low Carbon Gear Steel

Wear Property of Low-Temperature Bainite in the Surface Layer of a Carburized Low Carbon Steel

A Novel Method for the Development of a Low-Temperature Bainitic Microstructure in the Surface Layer of Low-Carbon Steel

Carbide-Free Bainite in Medium Carbon Steel

Low-temperature bainite in low-carbon steel

Microstructures and Mechanical Properties of Surface and Center of Carburizing 23cr2ni2si1mo Steel Subjected to Low-Temperature Austempering

N Rich Nanocrystalline Bainite in Surface Layer of Carbon Steel

Microstructure and properties of high-carbon bainitic steel

Gradient microstructure evolution and hardening mechanism of carburized steel under novel heat treatment

Microstructure Characteristics and Wear Performance of a Carburizing Bainitic Ferrite + Martensite Si/Al-Rich Gear Steel

Microstructure Characteristics and Wear Performance of a Carburizing Bainitic Ferrite plus Martensite Si/Al-Rich Gear Steel

Grain refinement mechanism of a 700 MPa ultralow carbon bainite heavy plate steel

Microstructure and mechanical properties of a low carbon carbide-free bainitic steel co-alloyed with Al and Si

Preparation Of Nanostructured Bainite In Medium-Carbon Alloy Steel

Microstructures and Properties of a Novel Carburizing Nanobainitic Bearing Steel

Microstructures and Mechanical Properties of a Modified High-C–cr Bearing Steel with Nano-Scaled Bainite

Performance of a Carburizing Bearing Steel After Surface Nanosized

Formation of Bainite in a Low‐Carbon Steel at Slow Cooling Rate – Experimental Observations and Thermodynamic Validation