Abstract:Proceedings of the Institution of Mechanical Engineers, Part C: Journal of Mechanical Engineering Science, Ahead of Print. The incremental sheet metal forming process, characterized by the step-by-step deformation of sheet metal using a simple die, is classified as a type of plastic deformation technology. This method allows for the formation of complex-shaped parts even without the use of a specialized die. Its notable characteristic lies in its low forming load and high flexibility. To accurately forecast finite element simulation outcomes for the incremental sheet forming of 2024-O aluminum alloy sheets, constructing a precise constitutive model is essential. Typically, the uniform strain range in traditional unidirectional tensile tests does not surpass 0.3, primarily due to the necking phenomenon. This limitation hampers the accurate prediction of the actual large plastic deformation process. To address this issue, a theoretical model describing the stress-strain relationship in metal plastic deformation processes is developed using crystal plasticity theory. The constitutive model for the forming of 2024-O aluminum alloy is then constructed by adjusting the hardening coefficient and hardening index. Utilizing the improved constitutive model, the incremental sheet forming process is simulated using ABAQUS software. Upon comparison with experimental results, it is observed that the Thickness Average Absolute Relative Errors (TAARE) of the adjusted constitutive model at forming angles of 60°, 55°, and 50° are 0.414%, 0.467%, and 0.256%, and The Thickness Root Mean Square Errors (TRMSE) are determined as 0.0121, 0.0116, and 0.0094, respectively. These results indicate that the constitutive model and parameters established in this study can adequately capture the mechanical behavior of 2024-O aluminum alloy during the incremental sheet forming process.

Finite Element Analysis of Multi-step Sheet Metal Forming Based on Ideal Forming Theory

Simulation and Analysis of UOE Pipe Production Processing by Three-Dimensional Finite Element Method

Finite Element Simulation of Two Stroke Deep Drawing in Sheet Metal Forming

Implementation of finite element analysis for solving the constraints in forming process of large steel parts

Finite element analysis of hydroforming process for sheet metal pairs

Explicit Analysis of Sheet Metal Forming Processes Using Solid-Shell Elements

A Multi-Phase Model for Transformation Plasticity Using Thermodynamics-Based Metallurgical Algorithm

Plastic Anisotropy Constitutive Equation of Sheet Metal and Its Stamping Process Simulation

Some improvements on the one-step inverse isogeometric analysis by proposing a multi-step inverse isogeometric methodology in sheet metal stamping processes

Research on incremental forming simulation based on an improved constitutive model

Finite Element Analysis and Design in Stainless Steel Sheet Forming and Its Experimental Comparison

Research on applying one-step simulation to blank design in sheet metal forming

An efficient multiphysics solid shell based finite element approach for modeling thin sheet metal forming processes

A Novel Method for Friction Coefficient Calculation in Metal Sheet Forming of Axis-Symmetric Deep Drawing Parts

Initial solution estimation of one-step inverse isogeometric analysis for sheet metal forming with complex topologies

Analysis and Design of Hydroforming Processes by the Rigid–plastic Finite Element Method

Development and application of sheet-forming simulation

Numerical Modelling for Efficient Analysis of Large Size Multi-Stage Incremental Sheet Forming

Mould Correction for Sheet-Metal Multi-Step Incremental Air-Bending Forming Based on Close-Loop Control and FEM Simulation

FEM model optimization study of mechanical properties and material selection in stamping process

Finite Element Simulation For Blanking Process Of Sheet Metal