Abstract:& nbsp;Considering electrical control of electrostatic precipitation, this paper discusses particle collection in terms of corona ionic wind, gas flow pattern and high-voltage power sources. Experiments and simulations were conducted with lab-scale and industrial electrostatic precipitators. In general, a larger electrostatic precipitator (ESP) index value leads to better ESP performance. To maintain the voltage, simulation results show that a three-phase power source could operate at a lower ripple factor of 0.8% and a shorter recovery time of 5 ms after spark-over than single-phase or high frequency transformer rectifiers. For an industrial ESP with several electric fields, optimal voltage or electric field strength drops from its inlet to outlet fields. It is normally around 3.3 kV cm(-1) with a large corona input power for the inlet field, and it drops to about 2.3 kV cm(-1) with a small input power to limit ionic wind induced reentrainment for the last field. For a typical Chinese 660 MW coal-fired boiler with a fourfield colder-side ESP, its outlet ash concentration and its PM10 and PM2.5 are usually around 15 mg m(-3), 12 mg m(-3) and 2 mg m(-3), respectively. According to particle image velocimetry observation and particle collection measurements, we found that the corona wind generated vortex can result in not only enhancement of collection but also particle reentrainment and/or the so-called 'bypass flow'. An optimum electric field inside the ESP exists to save energy and collect particles. For present ESPs, a higher electric field (>3.5 kV cm(-1)) generates strong electrohydrodynamic flow, which consequently undermines the collection due to turbulent flow. Advanced industrial automatic voltage controllers for three-phase transformer rectifier and double-wire ESPs have been developed according to those experimental results for both reducing emission and corona energy consumption.

Study on optimization of operating parameters in non-steady state process

A Numerical Model for Predicting Particle Collection Efficiency of Electrostatic Precipitators

Electrode Geometry Optimization in Wire-Plate Electrostatic Precipitator and Its Impact on Collection Efficiency

Characterization of Electrohydrodynamic Flow in a Plate-Plate Electrostatic Precipitator with a Wire-Cylinder Pre-Charger by Data-Driven Vortex and Residence Time Analysis

Electrode Configurations Inside an Electrostatic Precipitator and Their Impact on Collection Efficiency and Flow Pattern

Electrical Control of Electrostatic Precipitation

Recent Progress of Dry Electrostatic Precipitation for PM 2 . 5 Emission Control from Coal-fired Boilers

Current Density and Efficiency of a Novel Lab ESP for Fine Particles Collection

Design of the electrode structure for the dust removal efficiency optimization of electrostatic precipitator

Experimental Study On Collection Performance Of Dipolar Charging Electrostatic Precipitator

Experimental Study on Control Factors of Influence on Electrostatic Precipitator Efficiency

Performance study of a new type of collection equipment for unorganized fumes from aluminum electrolysis

Study on performance of electrostatic precipitator under multi-physics coupling

Dust Removal Performance of Two-Stage Electrostatic Precipitators and Its Influencing Factors

A Real-Time Optimization Method for Economic and Effective Operation of Electrostatic Precipitators

A Numerical Investigation of the Effect of Dust Layer on Particle Migration in an Electrostatic Precipitator

Experiments on Enhancing the Particle Charging Performance of an Electrostatic Precipitator

Improving the removal of particles via electrostatic precipitator by optimizing the corona wire arrangement

Electric dust removal system optimization control method based on hybrid model

Enhancement of particle collection efficiency considering the structural interplay: particle motion characteristics analysis

Theoretical and Experimental Study on V-I Characteristics of Electrostatic Precipitator for Dust Resistivity in Wide Range