Abstract:This article presents a wideband millimeter-wave power amplifier (PA) with a capacitive stability enhancement technique. It is composed of three differential cascode stages to attain high-power gain and large output power. To ensure the stabilization of the amplifier, a robust technique based on a series base capacitor is proposed and applied in each stage. Each capacitor creates a low-frequency zero to adjust the phase and amplitude responses of the differential cascode structure. As a result, the phase margin of the loop gain is increased remarkably. By adjusting the series base capacitors, the low-frequency zeros and gains of the three stages can be optimized. Therefore, the operating bandwidth is also extended. Meanwhile, a transformer-based four-path power combination network with a large current capacity is developed to further enlarge the output power. The circuit is demonstrated in a commercial 0.13 μm SiGe BiCMOS process. According to the measurement results, the PA obtains a saturated output power (P Sat ) of 18.5 dBm and output referred 1-dB compression point (OP 1dB ) of 16.32 dBm at 77 GHz. The tested small-signal gain is 26.7 dB at 77 GHz. Its 3 dB gain bandwidth is beyond 21.5 GHz, which ranges from 68.5 to 90 GHz. The P Sat variation is less than 0.57 dB at the frequency range from 70 to 85 GHz. The measurement also shows the PA with the proposed technique is unconditionally stable over the entire frequency band. The chip area is only 0.684 mm 2 .

Power Amplifier Driver for SDR Transmitter with High Gain Tuning Range and Dynamic Power Control.

A High Linearity Class AB Power Amplifier for Sub-1 GHz Applications

A CMOS 135–150 GHz 0.4 dBm EIRP transmitter with 5.1dB P1dB extension using IF envelope feed-forward gain compensation

A 68.5~90 GHz High-Gain Power Amplifier with Capacitive Stability Enhancement Technique in 0.13 Μm SiGe BiCMOS

A 30-680-mhz GaAs Phemt Power Amplifier with Guanella-type Transformers Integrated on a Flexible Printed Circuit Board

Analysis and Design of Wideband Low Noise Amplifier with Digital Control

A 0.1&#x2013;5ghz SDR Transmitter with Dual-Mode Power Amplifier and Digital-Assisted I/Q Imbalance Calibration in 65nm CMOS

Analysis and Implementation of Derivative Superposition for A Power Amplifier Driver

A 0.13µm CMOS 1.5-to-2.15ghz Low Power Transmitter Front-End for SDR Applications

Design and Implementation of 75 W RF Power Amplifier for Digital TV Transmitter

A 400M-510MHz On-Chip Transformer-Based RF Power Amplifier with 22.5dBm Output Power and 48% PAE.

A 0.1-5.0 GHz SDR Transmitter with Current-Mode Power-Mixer and Self-Calibration Scheme in 65 Nm CMOS

A Wideband Power Amplifier in 65 nm CMOS Covering 25.8 GHz–36.9 GHz by Staggering Tuned MCRs

High efficiency class-E RF power amplifier for wireless power transfer system

A 110-to-130ghz SiGe BiCMOS Doherty Power Amplifier with Slotline-Based Power-Combining Technique Achieving >22dbm Saturated Output Power and >10% Power Back-off Efficiency.

A Compact 19.7-to 43.8-Ghz Power Amplifier with 20.3-Dbm $p_{\mathrm{sat}}$ and 35.5% PAE in 28-Nm Bulk CMOS

A 0.1–1.5G SDR Transmitter with Two-Stage Harmonic Rejection Power Mixer in 65-Nm CMOS

A 77-Ghz Power Amplifier with Digital Power Control for Multi-Mode Automotive Radar in 28-Nm Bulk CMOS.

A 900 MHz,21 Dbm CMOS Linear Power Amplifier with 35% PAE for RFID Readers

A Fully Integrated High-Efficiency Three-stage Doherty Power Amplifier for Small-cell Application

Efficiency-enhanced Self-Biased PA Driver for Multi-Standard Applications