Abstract:This article presents a comprehensive study on shorted dipole antennas aiming for low-cost radio frequency identification (RFID) reader applications. Starting from a low-profile shorted bowtie dipole antenna, it is found that by varying the shorting wall position, three different types of resonant antennas could be realized with different radiation features. A low-profile planar inverted F antenna (PIFA) -type dipole is obtained by moving the shorting wall toward the feeding, which exhibits a low resonance frequency without obvious back lobe radiation or sidelobes. When the shorting wall is placed in the middle of the radiating patch, a mushroom-type dipole antenna can be built. A zeroth-order mode is also observed. This structure differs from the magnetoelectric dipole due to a low-profile structure. Placing the wall toward the end of the dipole arm leads to a loop-type antenna with a broader beam and a reduced gain. It also shifts the resonance toward the higher frequency. Based on the PIFA- and mushroom-type structures, two circularly polarized antennas with crossed shorted dipoles are designed and investigated carefully. Finally, two optimized, compact, and low-cost RFID reader antennas based on simple metal stamping process and screws are designed, fabricated, and tested, showing an excellent RF reading range. This study demonstrates that for the shorted dipole antennas, miniaturization and bandwidth control can be achieved simultaneously. Particularly, for higher gain and smaller size, the shorting wall should be placed close to the feeding to suppress the loop mode. For omnidirectional radiation, the loop mode should be enhanced by moving the shorting wall close to the end of the dipole arm.

Linearly-tapered RFID tag antenna with 40% material reduction for ultra-low-cost applications

Bending Effect on Antenna with Radiation Performance for Electronic Tag

A novel printed folded dipole antenna used for modern RFID system

A Miniaturized 2.45ghz RFID Tag Antenna Using Planar

Composite Spiral Antenna with Π Snowflake Fractal PBG Structure Designed for Modern RFID System

A single port dipole for UHF RFID tag antennas with eliminated read-orientation sensitivity

A MINIATURIZED PRINTED DIPOLE ANTENNA WITH V-SHAPED GROUND FOR 2.45 GHZ RFID READERS

Analysis and Design of a Low-Cost RFID Tag Analog Front-End

Design of Compact Passive Tag Antenna for Practical Rfid Applications

A Low-Profile Metal-backed Dipole Loaded with Closely Coupled Arc-shaped Open Stubs for On-metal Tag Design with Wide Frequency Tuning Capability

Low Profile Metal Tolerant UHF RFID Tag with Lumped Elements for Post-Manufacturing Frequency Tuning

Miniaturized Circularly Polarized Metal Antenna with a Shorting Pin for Low Cost RFID Application

Design and Radiation Mechanism Analysis of a Multi‐usage Ultra‐high Frequency Radio Frequency Identification Tag Antenna

Dual-Dipole Uhf Rfid Tag Antenna with Quasi-Isotropic Patterns Based on Four-Axis Reflection Symmetry

Characterization of Shorted Dipole Antennas for Low-Cost RFID Reader Applications

An Antenna Design for the Miniaturization of the RFID Tag

Metamaterial‐based, Miniaturised Circularly Polarised Antennas for RFID Application

UHF-RFID Tag Chip Integrated Reader Antenna Array

Compact Rfid Tag Antenna with Circular Polarization and Embedded Feed Network for Metallic Objects

Circular Multi‐usage RFID Tag Antenna with Coding Ability for Chipless Application

A UHF RFID Tag Antenna Placeable on a Metal Surface Without Degraded Performances