Miniaturized Circularly Polarized Metal Antenna with a Shorting Pin for Low Cost RFID Application

Yang Cheng,Yuandan Dong,Yongsheng Pan
DOI: https://doi.org/10.1109/ieee-iws.2019.8804033
2019-01-01
Abstract:A single-feed, miniaturized circularly polarized (CP) metal patch antenna with a shorting screw or pin for low cost Radio-Frequency Identification (RFID) application is proposed in this paper. Traditional dielectric substrate is replaced by air in this design to achieve higher radiation efficiency and lower cost aiming for mass production. Based on the conventional approach of CP patch antennas using truncated corners, an additional shorting screw/pin is added, together with slits and a circular slot in the middle to enhance the impedance and axial ratio (AR) bandwidth without increasing the antenna size or tuning the feeding position. The effect of different pin positions on antenna performance is studied. This antenna is carefully designed, fabricated and tested with a very low cost. Measured results show that the antenna has a -10 dB fractional impedance bandwidth of 7.3% and an AR bandwidth of 1.6%. The antenna shows an electrical size of 0.396λ * 0.396λ * 0.035λ at 886 MHz, a measured average gain of 8 dBi and a radiation efficiency better than -1 dB across the designed 886-950 MHz UHF RFID band.
What problem does this paper attempt to address?