Abstract:It is well known that the electrochemical performance of spinel LiMn2O4 can be improved by Al doping. Herein, combining X-ray diffraction, Raman spectroscopy, X-ray photoelectron spectroscopy, and spherical aberration-corrected scanning transmission electron microscopy (Cs-STEM) with in situ electron-beam (E-beam) irradiation techniques, the influence of Al doping on the structural evolution and stability improvement of the LiMn2O4 cathode material is revealed. It is revealed that an appropriate concentration of Al3+ ions could dope into the spinel structure to form a more stable LiAlxMn2–xO4 phase framework, which can effectively stabilize the surface and bulk structure by inhibiting the dissolution of Mn ions during cycling. The optimized LiAl0.05Mn1.95O4 sample exhibits a superior capacity retention ratio of 80% after 1000 cycles at 10 C (1 C = 148 mA h g–1) in the voltage range of 3.0–4.5 V, which possesses an initial discharge capacity of 90.3 mA h g–1. Compared with the undoped LiMn2O4 sample, the Al-doped sample also shows superior rate performance, especially the capacity recovery performance.The Supporting Information is available free of charge at https://pubs.acs.org/doi/10.1021/acsami.1c11315.Rietveld analysis, SEM images and elemental mapping of LiAlxMn2–xO4, corresponding FFT patterns of the HAADF images, variations and fitting curves between Z′ and ω–0.5 in LiMn2O4 and LiAl0.05Mn1.95O4, HAADF images and EDS quantitative results of LiMn2O4 and LiAl0.05Mn1.95O4 samples before and after 1000 cycles at 10 C, thickness distribution results by EELS measurements of LiMn2O4 and LiAl0.05Mn1.95O4 samples, and results obtained from the Rietveld analysis and XPS fitting parameters (PDF)This article has not yet been cited by other publications.

Effects of Aluminum Doping on the Performance of Lithium Ion Battery Material Li4ti5o12

Structural and Electrochemical Characteristics of Li4−xAlxTi5O12 As Anode Material for Lithium-Ion Batteries

Effects of a dopant on the electrochemical properties of Li4Ti5O12 as a lithium-ion battery anode material

Effects of dopant on the electrochemical performance of Li4Ti5O12 as electrode material for lithium ion batteries

Influence of Doping on the Electrochemical Properties of Li4Ti5O12

Synthesis and Electrochemical Performances of Li4Ti4.95Al0.05O12/C As Anode Material for Lithium-Ion Batteries

Effects Of Aluminum Doping On Cobalt-Free Lithium-Iron-Nickel-Manganese-Oxygen Cathode Materials For Lithium-Ion Batteries

Study on the Effect of Li Doping in Spinel Li4+xTi5−xO12 (0 ⩽ X ⩽ 0.2) Materials for Lithium-Ion Batteries

Role of Al-doping with Different Sites Upon the Structure and Electrochemical Performance of Spherical LiNi0.5Mn1.5O4 Cathode Materials for Lithium-Ion Batteries

Improving the electrochemical properties of Al, Zr Co-doped Li4Ti5O12 as a lithium-ion battery anode material

Understanding the Effect of Al Doping on the Electrochemical Performance Improvement of the LiMn 2 O 4 Cathode Material

Synthesis of LiNiO2 cathode materials with homogeneous Al doping at the atomic level

Preparation and effects of Mg-doping on the electrochemical properties of spinel Li4Ti5O12 as anode material for lithium ion battery

High-rate Performance of LiNi0.5Mn1.45Al0.05O4 Cathode Material for Lithium-Ion Batteries

Al Ions Doping Effect on The Diffusion Coefficient and Capacity of Li4Ti5O12 (Lithium Titanate, LTO) in Lithium-Ion Battery Anode

Co‐doping of Al3+ and Ti4+ and electrochemical properties of LiNiO2 cathode materials for lithium‐ion batteries

Impact of Fe Doping on Performance of NaTi2(PO4)3/C Anode for Aqueous Lithium Ion Battery

An In-Depth Understanding of the Effect of Aluminum Doping in High-Nickel Cathodes for Lithium-Ion Batteries

Improving the Cycle Stability of LiNiO2 through Al3+ Doping and LiAlO2 Coating

Synthesis and Characterization of Al-Doped Li4Ti5O12 with Sol Gel Method for Anode Material Lithium Ion Battery

Effects of Al doping on the electrochemical performances of LiNi0.83Co0.12Mn0.05O2 prepared by coprecipitation