Abstract:Pd-based constituents have been widely used for sensing H 2 due to the incredible selectivity, however, the sensitivity and measuring range in anaerobic ambience are largely limited for these using electronic signals. The variations between Pd and coincided hydride would typically increase resistance upon absorbing H 2 , whereas the intrinsic α - β phase transition alters the regularity of response features. Surprisingly, an inverse response has been detected by alloying Ag into Pd lattice, and this negative trend could be resulting from a new mechanism based on the experimental investigation and first-principles calculations. It is the contribution of modified Pd/Ag ratio, which optimizes the electronic band structure and density of states (DOS), thus a trade-off between free electron concentration and coincided scattering strength, would tune the response trend and make a switch. Consequently, the resistance of films with proper Ag contents, would be decreased at low H 2 concentrations (10 ppm-4 vt.%), and the detection range can be widened as the trend reverses to be positive at high concentrations. These, combined with the ultralow detection limit of 10 ppm, and proportional sensor response values from − 0.5% of 10 ppm H 2 to − 3.8% of 4 vt.% at 1 atm, confirm the promising virtues of anaerobic ambience used Pd-based sensors configuring inverse response. Furthermore, our study elucidates that alloying proper elements into Pd to modify the electronic band structure and DOS on Fermi energy, may be an effective strategy for promoting H 2 sensing features.

Optimizing Hydrogen Sensing Behavior by Controlling the Coverage in Pd Nanoparticle Films

Fast response characteristics of hydrogen sensors based on Pd nanoparticle films with controlled coverage

Optimizing coverage of palladium nanoparticles for a highly sensitive hydrogen gas sensor based on nanogaps via spray-deposition

Micro Hydrogen Sensor Based on Pd-Ag Nanofilm

The effects of Ni contents on hydrogen sensing response of closely spaced Pd–Ni alloy nanoparticle films

Dense palladium nanoparticle arrays with controlled coverage for fast hydrogen sensors

Response Behavior of a Palladium Nanoparticle Array Based Hydrogen Sensor in Hydrogen–nitrogen Mixture

Hydrogen responses of ultrathin Pd films and nanowire networks with a Ti buffer layer

Hydrogen sensing of nanoporous palladium films supported by anodic aluminum oxides

Nanoporous Pd Film Sensors for Detection of High Concentration Hydrogen

Surface Plasmon Resonance Hydrogen Sensor by Using a Au-Pd Thin Film Transducing Layer

Volume-Expansion-Enhanced Pinning of Nanoporous Pd Films for Detection of High-Concentration Hydrogen

A Novel Composite Hydrogen Sensor Based on Pd Nanoclusters/Tio2 Nanotube Arrays

Boosting room temperature response of Pd-based hydrogen sensor by constructing in situ nanoparticles

Pd Nanoparticle Film on a Polymer Substrate for Transparent and Flexible Hydrogen Sensors.

Ultrasensitive and Wide‐Range Flexible Hydrogen Sensor Based on Pd Nanoparticles Decorated Ultrathin SnO2 Film

High Performance Hydrogen Sensor Based on Pd/TiO2 Composite Film

Tuning the response trend of anaerobic ambience used Pd-based hydrogen sensor by engineering electronic band

Computational Design of Alloy Nanostructures for Optical Sensing of Hydrogen

A Novel Hydrogen-Sensitive Sensor Based on Pd Nanorings/tnts Composite Structure

High Response and ppb-Level Detection toward Hydrogen Sensing by Palladium-Doped α-Fe2O3 Nanotubes