Abstract:Wide-viscosity-range impellers have extensive demands and applications in process industry. The gas–liquid dispersion and mass transfer characteristics of wide-viscosity-range impellers including Large-double-blade (LDB) impeller, Fullzone (FZ) impeller and Maxblend (MB) impeller in water solutions of xanthan gum were investigated experimentally and compared. The influences of gas flow rate, impeller speed and polymer concentration of liquid on the power consumption, overall gas holdup εg and mass transfer coefficient KLa were also analyzed. On this basis, the appropriate operating parameters and impeller type were determined. The results indicate that with rising flow rate, the higher εg and KLa can be achieved with a drop in power consumption, and a relatively high flow rate is recommended on the premise of guaranteeing the complete dispersal condition in aerated vessel. Higher impeller speed provides better gas–liquid dispersion and mass transfer performance, but results in more power consumption simultaneously. The appropriate impeller speed should be just enough to meet the requirements of εg and KLa. It also is found that the increasing concentration of water solution of xanthan gum adds to the complexity of gas dispersion and mass transfer in aerated vessel. Under the same specific power consumption PV, the εg and KLa are positive and negative correlation with the polymer concentration of liquid, respectively. Specially, when the concentration of water solution of xanthan gum is relatively low, the FZ impeller exhibits the best gas dispersion and mass transfer performance under the same specific power consumption. Nevertheless, the mass transfer performance of FZ impeller deteriorates significant when the concentration of water solution of xanthan gum increases to 1.00 wt%, and the MB impeller becomes the most appropriate impeller type in this condition.

Optimization of Maxblend Impeller Diameter in High Viscous Fluid by CFD

Investigation of Gas–liquid Dispersion and Mass Transfer Performance of Wide-Viscosity-range Impellers in Water Solutions of Xanthan Gum

Simulation of flow field of pseudoplastic fluids agitated by Maxblend impeller

Experimental Study on Micromixing Characteristics of Novel Large-Double-blade Impeller

Experimental Investigation on Drawdown of Floating Particles in Viscous Systems Driven by Coaxial Mixers

Numerical investigation on the intensification of coaxial slurry mixing systems

Experimental and Computational Analysis of the Impeller Angle in a Flotation Cell by PIV and CFD

Numerical Simulation of Mixing Process in Pseudoplastic Fluids Agitated by Maxblend Impeller in Stirred with High Ratio of Height to Diameter

Numerical Simulation of Power Consumption and Mixing Characteristics of Novel Large-Double-blade Impeller

Numerical Simulation of Mixing Processes for Pseudoplastic Fluids in Industrial Scale Stirred Tank Agitated by Two Types of Impellers

Optimization of a Centrifugal Impeller on Blade Thickness Distribution to Reduce Hydro-Induced Vibration

Impeller design criterion based on numerical simulation of stock pump flow field and its application

Micromixing Simulation of Novel Large-Double-Blade Impeller

CFD Simulation of the Mixing and Dispersing of Floating Particles in a Viscous System

The Influence of Impeller Combination on the Gas-Liquid Dispersion Performance of a Coaxial Mixer in Viscous Fluids

The Optimization of A Low Specific Speed Pipeline Pump

Cavitation Performance Improvement of High Specific Speed Mixed-Flow Pump

Numerical Simulation of Dense Solid-Liquid Mixing in Stirred Vessel with Improved Dual Axial Impeller

CFD Research on the Influence of 45° Disk Turbine Agitator Blade Diameter on the Solid–Liquid Mixing Characteristics of the Cone-Bottom Stirred Tank

CFD simulation on shear-thinning gas-liquid dispersion in coaxial mixer