Abstract:Pore structure is an important factor influencing coke strength, while the property of coke is essential to maintaining gas and liquid permeability in a blast furnace.Therefore, an in-depth understanding of the pore structure evolution during the graphitization process can re-veal the coke size degradation behavior during its descent in a blast furnace. Coke graphitization was simulated at different heating temperat-ures from 1100 to 1600°C at intervals of 100°C. The quantitative evaluation of the coke pore structure with different graphitization degree was determined by vacuum drainage method and nitrogen adsorption method.Results show that the adsorption and desorption curves of graphit-ized coke have intersection points, and the two curves did not coincide, instead forming a "hysteresis loop." Based on the hysteresis loop ana-lysis, the porous structure of the graphitized coke mostly appeared in the shape of a "hair follicle." Furthermore, with an increase in heating temperature, the apparent porosity, specific surface area, total pore volume, and amount of micropores showed good correlation and can di-vided into three stages: 1100–1200, 1200–1400, and 1400–1600°C. When the temperature was less than 1400°C, ash migration from the inner part mainly led to changes in the coke pore structure. When the temperature was greater than 1400°C, the pore structure evolution was mainly affected by the coke graphitization degree. The results of scanning electron microscopy, energy dispersive spectrometry, and ash content ana-lyses also confirmed that the migration of the internal ash to the surface of the matrix during the graphitization process up to 1400°C contrib-uted to these changes.

Theoretical Model of Heating Patterns During Carbonization of Green Carbon Blocks

Effect of kneading and carbonization temperature on the structure of the carbon block for thermally conductive bulk graphites

Binding Natural Graphite with Mesophase Pitch: A Promising Route to Future Carbon Blocks

Pore Structure Evolution During the Coke Graphitization Process in a Blast Furnace

Modeling of Coal Drying before Pyrolysis

A Granular-Biomass High Temperature Pyrolysis Model Based on the Darcy Flow

Experiments and Modeling for Thermal Conductivity of Graphite Nanoplatelets/carbon Composites

Carbon structural evolution and interfacial reaction mechanism investigation of the green anode in kneading and baking via ReaxFF-MD and force-biased Monte Carlo

Response surface optimization of pitch phase change densification using composite phenolic resin co-carbonization to prepare high performance carbon refractories

An analysis of the carbonization process of coal-based activated carbon at different heating rates

The Effect of Oxygen Content in Binderless Cokes for High-Density Carbon Blocks from Coal Tar Pitch

Computer Simulation of Carbonization and Graphitization of Coal

Modeling and Simulation of Carbonization Chamber Heat Transfer Process in Coke Oven

Insight into reaction performance and product formation in a novel coal pyrolyzer of pilot-scale test

An analysis of the carbonization process and volatile-release characteristics of coal-based activated carbon

Effect of heating rate of pyrolysis on coal particle pore structure

The Mechanism of Expansion During the Baking of a Hot-Pressed Graphite Green Body

In-situ study of the heating rate effects on covalent bonds conversion and pore/carbon microcrystal evolutions of coal molecule during coking

Study on the carbonization process in the fabrication of pebble fuel elements

CFD Modeling of Coal Pyrolysis in Externally Heated Fixed-Bed Reactor

Carbon Blocks from Natural Flake Graphite and Mesophase Pitch: Fabrication Processing, Microstructre, Mechanical Property, and Electrical Perfromance