Abstract:Pile-supported embankment is popularly used for constructing high-speed railways on soft soils. With train running at high speed, the dynamic load on the pile top generated by the train passages increases noticeably. To keep the long-term settlement of the railway track within a reasonable range, it is necessary to investigate the settlement of piles in soils simultaneously subject to the monotonic load caused by the weight of the track structure and embankment as well as the cyclic load caused by the train passages. In this paper, model tests on piles in silt soil under combined monotonic and cyclic loading were conducted. The behavior of a pile in saturated silt was investigated by measuring pile settlement, soil pressure on the pile surface, and pore water pressure in the soil adjacent to the pile. Based on the model testing results, the ratio of the mean value of cyclic load to the ultimate bearing capacity of the pile (P-m/P-u) and the ratio of the half amplitude of the cyclic load to the ultimate bearing capacity of the pile (P-cyc/P-u) were identified as the main factors dominating the development of pile settlement. A higher P-cyc/P-u leads to faster accumulation in the pile settlement, and a higher P-m/P-u facilitates this process. A chart with three zones determined by the combination of P-cyc/P-u and P-m/P-u has been proposed to distinguish the settlement trends of the piles: stable zone, metastable zone and unstable zone. The combination of P-cyc/P-u and P-m/P-u located in the stable zone generates very small settlement. Moreover, for the loading combination in the metastable zone, an analytical model was proposed to predict the cyclic pile settlement subject to cyclic load with large cycles. The advantage of the model is that the coefficient of friction at the pile surface and the cyclic strain degradation parameter are incorporated. Finally, a case study is presented to demonstrate the application of the proposed chart and the prediction method on cyclic pile settlement in the design of piled embankment of high-speed railways.

Experimental investigation of cumulative settlement of cyclically loaded pile

Advanced laboratory investigation of axial cyclic loading in silica sands

Stress Paths Measured Around A Cyclically Loaded Pile In A Calibration Chamber

Lateral Cyclic Pile–soil Interaction Studies on a Rigid Model Monopile

Soil-pile interaction on an instrumented pile under cyclic axial loads in sand

Model Test on Bearing Capacity and Accumulated Settlement of Single Pile Subjected to Axial Cyclic Loading

Centrifuge Model Tests on Laterally Loaded Piles in Sand

Centrifuge Modelling of Lateral Cyclic Behaviour of a Tetrapod Piled Jacket in Soft Clay

Field Tests of Offshore Driven Piles Subjected to Lateral Monotonic and Cyclic Loads in Soft Clay

Experimental Investigation Of Performance Of Axially Cyclic Loaded Piles

Centrifuge Modelling of Lateral Loading Behaviour of a “Semi-Rigid” Mono-pile in Soft Clay

Model Tests on the Bearing Capacity of Precast Open-Ended Micro Pipe Piles in Soft Soil

Experimental Investigation on a Single Stiff Pile Subjected to Long-Term Axial Cyclic Loading

Experimental Study on Cyclic Settlement of Piles in Silt Soil and Its Application in High-Speed Railway Design

Experimental Study on Pile-Soil Interaction Response in Saturated Sand under Long-Term Horizontal Cyclic Loading

Experimental Investigation of Geosynthetic-Reinforced Pile-Supported Composite Foundations under Cyclic Loading

Studies on Bearing Characteristic of Open-Ended and Close-Ended Pipe Piles under High-Speed Railway Loadings

Time Effect of Settlement for Single Pile under Vertical Sustained Loading

Model tests of single pile vertical cyclic loading in calcareous sand

Field Study of Monotonic and Cyclic Lateral Behaviour of Piles in Soft Soils Improved with and Without Vacuum Preloading

Engineering Characteristics Of Composite Foundation With Rigid-Flexible And Long-Short Piles