Abstract:The study on the rock strata movement and the stress distribution law of stope under mining height control were carried out. Four groups of similar material simulation experimental models were established. The evolution law of overburden movement and deformation range under different mining heights and different geological conditions is obtained. The mining height controls the stress distribution of stope by adjusting the "three zones" of the roof. The mechanism of mining height influencing the stress distribution of the floor is proposed. There is an optimal mining height, which can make the pressure relief effect of stope best. When pressure relief mining of a non‐all‐coal protective layer, to realize the accurate regulation of the pressure relief range and pressure release value of mining height, it is necessary to carry out research on the migration of overburden and the stress distribution law of stope under mining height control. Through similar material simulation experiments, four groups of similar material simulation experimental models were established. The laws of rock strata movement and stress distribution at 2, 4, and 5 m mining heights under different geological conditions, and the laws of rock strata movement and stress distribution at 5 and 8 m mining heights under the same geological conditions were obtained. The research results show that the geological conditions and mining height do not affect the evolution of the rock strata movement range. The highest position of the strata movement and deformation is linearly related to the advancing distance of the coalface. The maximum height of rock strata movement increases abruptly when encountering the key strata, but it still has a linear relationship. The highest position of each expansion of the fracture zone has an exponential relationship with the advancing distance of the coalface. When the key strata are encountered, the maximum height of the fracture zone increases abruptly. The change in mining height only affects the distribution range of the "three zones." The mining height controls the stress distribution of stope by adjusting the "three zones" of the roof. With the increase in mining height, the caving zone and fracture zone range increase. The corresponding pressure relief range and pressure relief value show the change law of first increasing and then decreasing. There is an optimal mining height, which can make the pressure relief effect of stope best.

Time-Varying Optimization Study Of Mining Sequence Based On Reconstructed Mining Environment

Simulation of Mining-Induced Ground Damage Using Orthogonal Experiments to Determine Key Parameters of Super-Large Coalface: A Case Study in Shendong Coalfield in China

Study on Optimization of Stope Structural Parameters and Filling Scheme of Wawu Phosphate Mine in Yichang City, China

Stability analysis of open-pit gold mine slopes and optimization of mining scheme in Inner Mongolia, China

A path for evaluating the mechanical response of rock masses based on deep mining-induced microseismic data: A case study

Numerical Simulation on the Structural Parameter Optimization of Ore Block for Non-pillar Continuous Mining

Stability analysis of rock fracture and support performance in steeply dipping ore deposits with massive mining stopes

Study on the Stress and Deformation of Surrounding Rock and Support Structure of Super Large Section Tunnels Based on Different Excavation Methods

Evolution Characteristics of Overburden Instability and Failure under Deep Complex Mining Conditions

Study on Surrounding Rock Stability of Long-Span Coal Roadway under Influence of Mining and Support Technology Optimization

Mining Method Optimization of Gently Inclined and Soft Broken Complex Ore Body Based on AHP and TOPSIS: Taking Miao-Ling Gold Mine of China as an Example

Stability assessment of surrounding rock in downward mining route supported by slab-wall backfill structure

Experimental study on rock strata movement and stope stress distribution law under mining height regulation

Optimization and Stability of the Bottom Structure Parameters of the Deep Sublevel Stope with Delayed Backfilling

A Dynamic Intersecting Arrangement Model Based on Isolated Draw Zones for Stope Structure Optimization during Sublevel Caving Mining

Study on Optimization of Stope Structure Parameters of Room and Pillar Alternately Raised Mining with Backfill

Three Dimensional Finite Element Analysis of Parameters of Boundary Crown Pillar in Transition from Open-pit to Underground Mining

Study on roof breaking mechanism and support stability of steeply dipping seam and large mining height

Comprehensive evaluation of fault-controlled open-pit mine stability classification analysis and numerical simulation

Study on Deformation Response Law of Surrounding Rock in Solid Backfill Mining Stope

Determination of mining-induced stress based on mining face hydraulic support stress and micro-seismicity