Abstract:The breakdown and recovery characteristics of the highly repetitive (≤100 kHz) and short nanosecond (∼10 ns) pulsed discharge were investigated. It was found that if one pulse of 40 kV is applied, the air gap between two conical electrodes for a reliable breakdown is only 1 mm; however, if 1000 same pulses are repetitively applied, the longest gap that can be broken down dramatically increases with the increase in the repetitive rate and it reaches 90 mm at 100 kHz. During the preceding pulses that do not cause the breakdown of the gap, long streamers develop from both conical electrodes and nearly bridge the gap, which provides the residual and decaying plasma channels for the rapid breakdown of 90-mm gap in the following pulses, which was experimentally proved to be unique in the extremely non-uniform electric field. The voltage recovery was determined with the two-pulse method and found that the physical processes of the voltage recovery after the short nanosecond pulsed breakdown are similar to that after the microsecond pulsed breakdown, but the time needed for a full recovery in the gas density, in between 50 and 100 μs, is shorter by three orders than that after the microsecond pulsed breakdown. The faster recovery in the gas density may be understood from the small energy of 36 mJ in one nanosecond pulse, which does not induce a high perturbation in the gas density. The evolution in the discharge mode in a 15-mm gap, from corona to diffuse and finally to multichannel spark, with the applied voltage and the repetitive rate was observed. The formation of the multichannel spark is due to the limited energy per pulse that is not enough to heat the primary channel to high conductivity for the collapse of the gap voltage.

Single and Repetitive Short-Pulse High-Power Microwave Window Breakdown

Review of Recent Theories and Experiments for Improving High-Power Microwave Window Breakdown Thresholds

Experimental Investigation and Analysis of the LDMOS FET Breakdown Under HPM Pulses

Suppression of High-Power Microwave Window Breakdown by the Sweeping-out-electron Effect with an External Dc Bias Electric Field

Theory of Nanosecond High-Power Microwave Breakdown on the Atmosphere Side of the Dielectric Window

Electro-Thermal-Stress analysis of a LDMOS FET Breakdown under High Power Microwave pulses

The Influence of Desorption Gas to High Power Microwave Window Multipactor

Investigation on Dielectric Window Treelike Breakdown and Suppression under HPM in Vacuum

Plasma Propagation in the Microwave Window Breakdown at the Air/dielectric Interface

Improved Model for Window Breakdown at Low Pressure

Tree-like Breakdown Phenomena of Dielectric Window under X-band High Power Microwave in Vacuum

Rectangular Grooves Suppressing Multipactor Across High Power Microwave Dielectric Window

Damage phenomena of dielectric window material under X-band high power microwave

Study on Atmospheric Breakdown Experimental for Single Hpm Pulse

Numerical Simulations of High Power Microwave Dielectric Interface Breakdown Involving Outgassing

Monte Carlo Simulation of Microwave Air Breakdown in Parallel Plates Considering Electron-Surface Interaction

Experimental Research on Damage of Dielectric Materials under High Power Microwave in Vacuum

Breakdown, Discharge Modes, and Gaseous Recovery of Atmospheric Air with Repetitive 10 Ns Pulses

Simulation study of secondary electron multiplication on microwave dielectric window

Experimental Verification of Improving High-Power Microwave Window Breakdown Thresholds by Resonant Magnetic Field

Gas breakdown driven by L band short-pulse high-power microwave