Abstract:When the aircraft cruising at high altitude, the aerodynamic performance of the compressor sharply decreases due to the enhanced boundary layer separation loss. Therefore, it is of great significance to design the high-performance airfoils suitable for low Reynolds numbers (Re) to improve the aerodynamic performance of compressor. In this paper, numerical simulations were carried out on a high-loaded subsonic compressor cascade V103 at low Re. Meanwhile, a multi-objective optimization of blade profile was performed to get optimal solutions, and data mining techniques were applied to extract valuable design knowledge from the optimal database. The results show that the Pareto-optimal airfoils achieve a maximum reduction of 27.32% in total pressure loss coefficient under design condition and 36.71% under near stall condition. Compared with the original airfoil, the curvature distribution law of the camber line with larger values at both ends and smaller values in the middle is advantageous for the performance of the compressor cascade under design condition. This distribution pattern causes a forward shift for the loading distribution of airfoils, accompanied by an earlier transition onset. Additionally, it reduces adverse pressure gradient at the rear part of suction surface, which suppresses the development and growth of laminar separation bubble and delays the separation of turbulent boundary layer. Under near stall condition, maintaining larger leading edge angle and uniform flow diffusion is beneficial for improving the performance of compressor cascade. This is because the larger leading edge angle reduces incidence angle, while the uniform flow diffusion inhibits a great flow separation.

Aerodynamic Design of a Small Centrifugal Compressor

Optimization Design of Centrifugal Fan Impeller Based on Numerical Simulation.

Aerodynamic Design and Experimental Study of Small Flow Rate Centrifugal Compressor

Optimization Design of a Small Centrifugal Compressor

Preliminary Design of Centrifugal Compressor Using Multidisciplinary Optimization Method

AERODYNAMICS OPTIMUM DESIGN OF BLADES IN CENTRIFUGAL COMPRESSOR

Investigation of a Highly Loaded Transonic Centrifugal Compressor Using an Advanced Design Method

The Aerodynamic Design and Investigation of Loading Distribution of a Mixed Flow Compressor

Aerodynamic Design of Fan/Compressor Operated at Low Reynolds Number

Aerodynamic Optimization Design for All Condition of Centrifugal Compressor

An Aerodynamic Design and Numerical Investigation of Transonic Centrifugal Compressor Stage

Aerodynamic Design and Experimental Validation of Centrifugal Compressor Impellers with Small Flow Rate

Optimized design of a small type high speed centrifugal compressor

Redesign of a High Speed Micro-centrifugal Compressor

Performance Improvement of a Highly Loaded Transonic Centrifugal Compressor with Tandem Impeller and Freeform Blade Configuration

Extraction of Geometric Features and Analysis of Flow Mechanism of High Loaded Compressor Airfoils at Low Reynolds Number

Discussion on back-to-back two-stage centrifugal compressor compact design techniques

A Blading Design Method for Axial/centrifugal Compressor Airfoils Using Arbitrary Camber Lines

Optimization Of High Speed Centrifugal Compressor For A Micro Gas Turbine Based On Cfd And Fem Analysis

Numerical Investigation to Small High Speed Centrifugal Compressor

Aerodynamic Analysis and Three-Dimensional Redesign of a Multi-Stage Axial Flow Compressor