Abstract:To optimize the investment casting process when producing high quality large-size titanium alloy thin-wall components is a time-consuming job due to the complicated metallurgical process. Numerical simulation is a high-efficiency method compared with trial and error, and therefore is introduced to the investment casting process optimization to shorten the new product development cycle and reduce the production cost. In this study, weakly compressible model (WCM) and ununiformed finite difference mesh (UFDM) was developed to reduce the memory consumption and ensure the simulation efficiency. The precision of the WCM and UFDM were verified by numerical simulation of cavity heat convection in a square cavity and hydraulics simulation of centrifugal filling in a transparent cavity. The numerical simulation of the investment casting process of a titanium alloy thin-wall casing under different process conditions was accomplished using a self-developed software, and the distribution characteristics of potential shrinkage defects were predicted. It was found that the predicted defects in the titanium alloy casing matched well with the actual X-ray experimental results. For the components investigated in this paper, more numerical simulation results show that the centrifugal casting process with respect to gravity casting had no obvious improvements in the concentrated shrinkage defects, and the gravity casting process can be more reasonable from the engineering point of view.

Numerical Simulation of Vacuum Investment Casting Cartridge Receiver

Simulation Analysis of Thermal Stress During Casting Process of Large-Sized Alloy Steel Ingot

Numerical Simulation and Optimization of Indirect Squeeze Casting Process

Numerical Simulation of Solidification Process for Impeller Investment Casting Based on ProCAST

Numerical Simulation for the Investment Casting Process of a Large-Size Titanium Alloy Thin-Wall Casing

Numerical Simulation and Process Optimization of Vacuum Investment Casting for Be–Al Alloys

Numerical Simulation and Optimization of Investment Casting for Complex Thin-walled Castings

Prediction method of shrinkage cavity and shrinkage porosity in solidification process under low-pressure casting

Study on numerical simulation of mold-filling and solidification processes of shaped casting

Numerical Simulation of Investment Casting of Large Complicated Hollow Blade by ProCAST

Progress on Numerical Simulation of Mold Filling and Solidification Processes of Shaped Castings

Continuous Casting Mould for Square Steel Billet Optimised by Solidification Shrinkage Simulation

Studies on formation of shrinkage cavity and porosity of steel castings by taking filling process into account

Progress in numerical simulation of solidification process of shaped casting

Criteria for Prediction of Shrinkage Cavities and Porosity in Castings

Analysis of Casting Defects in Investment Casting by Simulation

Numerical simulation of shrinkage porosity defect in billet continuous casting

Numerical Simulation of Squeeze-Casting SiC3D/Al Ceramic Matrix Composites

Computer-Aided Engineering (CAE) Simulation for the Robust Gating System Design: Improved Process for Investment Casting Defects of 316L Stainless Steel Valve Housing

Numerical Simulation of Fluid Flow and Heat Transfer During Mold Filling for Die Casting

Progress in numerical simulation of casting process