Abstract:Mg-Zn-Sn-Mn alloy is a new type of age hardening wrought Mg alloy. However, the precipitation behavior of the alloy is still not well understood. A solution-treated Mg-6Zn-4Sn-1Mn alloy is selected as the experimental alloy in this paper. The hardening behavior, precipitate microstructure and precipitation sequence of the solution-treated alloy during single aging and double aging at 180 °C are systematically studied by means of XRD, OM, SEM, TEM, EDS and microhardness. The results show that four types of precipitated phases are successively precipitated in the experimental alloy during the aging treatment, namely, G.P. zone parallel to the (0001)α base plane, rod-like β1′(MgZn2) phase perpendicular to the (0001)α base plane, disc-like β2′ (MgZn2) phase parallel to the (0001)α base plane, and irregular β' (Mg2Sn or Mg3Sn) phase. The habitual plane of most β' phases is the (0001)α basal plane, and a small part of the β' phase forms a certain angle with the (0001)α basal plane. A large number of finely dispersed G.P. zones can provide the heterogeneous nucleation sites for the β1′ phase during the pre-aging stage, which promotes the nucleation of the precipitates during the second aging, so the peak aging hardness (87HV) of the double-aged alloy is much higher than that of the single-aged alloy (74HV), and the peak aging time (6 h) during second aging of the double aging is shorter than that (12 h) of single aging. The possible precipitation sequence of Mg-6Zn-4Sn-1Mn alloy during the isothermal aging treatment can be obtained, that is, α-Mn→β1′ (MgZn2)→β (MgZn) in the Mn-rich zone, and SSSS→G.P. zones→β1′ (MgZn2)→β2′(MgZn2)→β' (Mg2Sn or Mg3Sn)→(β (MgZn) and β (Mg2Sn)) in Zn-rich and Sn-rich zone.

A study of precipitation behavior of cast Mg-3Zn-0.5Cu-0.6Zr magnesium alloy

Age-hardening Behavior and Precipitates of As-Cast Mg-3Zn-1.5Cu-0.6Zr Mg Alloy

Precipitation Behavior of Cast Zc62 Magnesium Alloy

Atomic-scale study on the precipitation behavior of an Al-Zn-Mg-Cu alloy during isochronal aging

Effects of Cu Addition on Aging Precipitation Behavior of Cast Mg-3Zn-xCu-0.6Zr Magnesium Alloys

Investigations on Microstructure and Mechanical Properties of Cast Mg-Gd-Y-Zn-Zr-Nd Alloy

Microstructure and Mechanical Properties of Mg-Xy-1.5mm-0.4zr Alloys

Characterization of precipitates in aged Mg-4 wt%Zn alloy

The Microstructure and Mechanical Properties of As-cast Mg-10Gd-3Y-xZn-0.6Zr (x=0, 0.5, 1 and 2 Wt%) Alloys

Study on properties and precipitation behavior of 6000 series alloys with high Mg/Si ratios and Cu contents

Microstructural Characteristics and Mechanical Properties of Cast Mg–3Nd–3Gd–xZn–0.5Zr Alloys

Aging Behavior and Precipitate Characterization of Zn-rich Al–Zn–Mg–Cu Alloys with Various Mg and Cu Contents

Aging hardening and precipitate behavior of a solution-treated Mg-6Zn-4Sn-1Mn (wt.%) wrought Mg alloy

Characterization and Strengthening Effect of Precipitate Microstructure in Mg-3nd-3gd-0.2zn-0.5zr Alloy Aged at 225 °C

Microstructure and Age-Hardening of As-Cast Mg-5Zn-0.6Zr-1RE-2Y Magnesium Alloy Aged at Low Temperature

Influence of Mg Contents on Aging Precipitation Behavior of Al–3.5Cu–xMg Alloy

Influences of Mg content on the microstructures and mechanical properties of cast Al–2Li–2Cu–0.2Zr alloy

Precipitation and its effect on the mechanical properties of a cast Mg–Gd–Nd–Zr alloy

Microstructure and mechanical properties of Mg–4Al–4Nd–0.5Zn–0.3Mn alloy

Precipitation in an Al-Zn-Mg-Cu alloy during isothermal aging: Atomic-scale HAADF-STEM investigation

Effects of Mg/Zn ratio and pre-aging on microstructure and mechanical properties of Al–Mg–Zn–Cu alloys