Effect of inoculant parameters on AM60 Mg alloy semisolid slurry prepared by self-inoculation method (Ⅱ)

LI Yuan-dong,YANG Jian,MA Ying,QU Jun-feng,ZHANG Peng

DOI: https://doi.org/10.19476/j.ysxb.1004.0609.2010.11.019

2010-01-01

Abstract:The self-inoculant with the same composition as the melt of alloy was introduced into the melt. The effects of the inoculant parameters, such as addition method, particle size, addition amount and precursor microstructure, on grain refinement were investigated. The results indicate that the grain size of AM60 alloy is refined when the self-inoculant is introduced into the melt, and then the melt passes through a special cooling channel. A average grain size of 43.4 μm is gained when the addition amount of inoculants is up to 11% (mass fraction). The precursor microstructure of self-inoculants affects final solidification microstructure visibly of AM60 alloy. The smaller the microstructure of self-inoculant is, the better the final solidification microstructure is. The inoculant increases the thermal and constitutional fluctuation, and plays a role of heat absorption, nucleation, acceleration solidification during solidification of AM60 alloy, which is helpful for the formation of grain refining microstructure.