Abstract:We proposed a novel kind of absolute capacitive grating displacement measuring system with both high accuracy and long range in a previous article. The measuring system includes both a MOVER and a STATOR, the contact surfaces of which are coated by a thin layer of dielectric film with a low friction coefficient and high hardness. The measuring system works in contact mode to minimize the gap changes. This paper presents a theoretical analysis of the influence of some factors, including fabrication errors, installation errors, and environment disturbance, on measurement signals. The measuring signal model was modified according to the analysis. The signal processing methods were investigated to improve the signal sensitivity and signal-to-noise ratio (SNR). The displacement calculation model shows that the design of orthogonal signals can solve the dead-zone problem. Absolute displacement was obtained by a simple method using two coarse signals and highly accurate displacement was further obtained while using two fine signals with the help of absolute information. According to the displacement calculation model and error analysis, the error in fine calculation functions mainly determines the model's accuracy and is locally affected by coarse calculation functions. It was also determined that amplitude differences, non-orthogonality, and signal offsets are not related to the accuracy of the displacement calculation model. The experiments were carried out to confirm the abovementioned theoretical analysis. The experimental results show that the displacement resolution and error in the displacement calculation model reach ±4.8 nm and ±34 nm, respectively, in the displacement range of 5 mm. The experiments and the theoretical analyses both indicate that our proposed measuring system has great potential for achieving an accuracy of tens of nanometers and a range of hundreds of millimeters.

Modelling and Characteristic Analysis of A Displacement Sensor with Liftoff Compensation

Modeling and Characteristic Analysis of a Novel Displacement Sensor with Lift-off Adjustment

Analysis of mechanical errors of planar capacitive sensor for two dimensional displacement measurement

Study of Differential Magnet-moving Type Velocity Sensor

A Displacement Sensing Method Based on Permanent Magnet and Magnetic Flux Measurement

A New Dual Magnetic Sensor Probe for Lift-off Compensation in Magnetic Flux Leakage Detection.

Position Estimation Accuracy Improvement Based on Accurate Modeling of Self-Sensing Active Magnetic Bearings

Electromagnetic field analysis and modeling of a relative position detection sensor for high speed maglev trains

Design And Realization Of A Three Degrees Of Freedom Displacement Measurement System Composed Of Hall Sensors Based On Magnetic Field Fitting By An Elliptic Function

Research on New Displacement Sensor Used in Active Magnetic Bearing Systems

Design of non‐contact capacitive displacement detection methods for magnetic levitated sphere

Study on Fast and Precise Measurement of Three-Dimensional Displacement Using Hall Sensors

AC Magnetic Flux Leakage Testing With Real-Time Liftoff Compensation Using Double Layer Parallel-Cable Probe

A Starting Value Computation Method for Displacement Measurement Based on Magnetic Field

A Parameter Adaptive Feedforward Compensation Method for SPMSM Using Hall-Effect Sensor

An Absolute Linear Displacement Sensor Based on Orthogonal Dual Traveling Wave Magnetic Field

An Eddy Current Displacement Sensor Based on Piecewise Linearization of Inverse Function

Planar 3-Degree-of-freedom Position Sensing Method Based on Decoupling Using a Linear-Hall Array

Error Analysis and Modeling for an Absolute Capacitive Displacement Measuring System with High Accuracy and Long Range.

A novel approach for sensitivity improvement of axial inductive displacement sensor

Analysis and Compensation of Hall Sensor-Based Position Detection Errors in TPMSLM