Abstract:The Self-sensing Active Magnetic Bearings (SSAMBs) which feature for the simplification of independent displacement sensors, contribute to both cost reduction and convenience in control and assembly. The key point of this technique is to accurately estimate rotor position signals directly from coil voltages or currents, thus the actuator itself also serves as a virtual displacement sensor. Although several feasible approaches have been proposed to realize the self-sensing process, there still lie limitations in estimation accuracy, robustness and dynamic performance of the system. In fact, due to the nonlinear property of the self-sensing process, few accurate models are available for quantitative analysis of the estimation accuracy, and this restricts further development of this technique. Focusing on the modulation type SSAMBs, an accurate analytical model of the self-sensing in frequency domain is firstly established in this paper. Eddy current effects and filter properties are also considered for better accuracy. Based on this model, we evaluate possible estimation error sources during the self-sensing process, and investigate if the estimation accuracy can be improved fundamentally by selecting main system parameters properly. In this way, the estimation accuracy gets further improved under existing compensation methods, and better system robustness and dynamic performance can be achieved. Finally, the analytical model and associated conclusions are validated through static experiment, 4-Degree of Freedom (DOF) self-sensing rotor levitation experiment and 0-5000 rpm rotating operation experiment on a 4-DOF rigid rotor-radial SSAMBs platform. (C) 2016 Elsevier B.V. All rights reserved.

Planar 3-Degree-of-freedom Position Sensing Method Based on Decoupling Using a Linear-Hall Array

A Position Measurement Method for 3-Degree-of-freedom Motion Based on Magnetic Detection.

Real-Time Orientation-Invariant Magnetic Localization and Sensor Calibration Based on Closed-Form Models

A novel planar 3D magnetic position measurement methodology using linear Hall sensors

A 6-DOF Measurement Solution for Permanent Magnet Synchronous Planar Motors Based on Motion Continuity Principle.

Planar Position for Permanent-Magnet Synchronous Motor Using Historical and Magnetic-Detection Information

A Hall Sensor-Based Position Measurement with On-Line Model Parameters Computation for Permanent Magnet Synchronous Linear Motor

Position Estimation Accuracy Improvement Based on Accurate Modeling of Self-Sensing Active Magnetic Bearings

An Improved Rotor Position Estimation Method for PMSM Using Low-Resolution Hall-Effect Sensors

A Novel Method on Real-Time Measurement of 2-DOF Motions of Spherical Ultrasonic Motor

Six Degrees of Freedom Displacement Measurement System for Wafer Stage Composed of Hall Sensors

Planar 3-DOF Magnetic Micro-motion Stage and Its Decoupling Control

Optimization of Hall Position Sensor for Permanent Magnet Synchronous Linear Motors

Permanent-magnet Synchronous Planar Motor Displacement Measurement Based on UKF Method

Study on Fast and Precise Measurement of Three-Dimensional Displacement Using Hall Sensors

An improved rotor position estimation in PMSM with low-resolution hall-effect sensors

Investigation of Cross-Coupling Effect of a 3-DOF Magnetic Bearing Using Magnetic Circuit Method

Analog-Hall-Sensor-Based Position Detection Method With Temperature Compensation For Permanent-Magnet Linear Motor

Modeling and Design of a 3-DOF Magnetic Bearing with Toroidal Radial Control Coils

Rotor Position Estimation Strategy for Self-Sensing Active Magnetic Bearing Considering Eddy Currents

Wide Linearity Range 3D Magnetic Sensor and Angular Position Detector Based on a Single FePt Spin-Orbit Torque Device