Fabrication of Gd2O2S:Tb scintillation ceramics from the uniformly doped nanopowder
Xinyou Huang,Jiyang Ding,Xin Liu,Xiaoying Li,Haohong Chen,Dianju Hu,Danyang Zhu,Tengfei Xie,Jianrong Zhou,Xingfen Jiang,Zhijia Sun,Jiang Li
DOI: https://doi.org/10.1016/j.optmat.2021.111192
IF: 3.754
2021-07-01
Optical Materials
Abstract:Single-phase 2Gd2O3·(Gd,Tb)2(SO4)3·nH2O precursor with strong crystallinity was synthesized by the water-bath method through optimizing the introducing method of Tb3+ doping, where Tb3+ was introduced from Tb(NO3)3. The formation process and phase evolution of the precursor were analyzed in detail. Compared with the conventional method of introducing Tb3+ via Tb4O7, the inhomogeneous doping caused by the appearance of 2Tb2O3·(Gd,Tb)2(SO4)3·nH2O in the precursor was avoided. Pure Gd2O2S:Tb nanopowders with layered structure were obtained after calcination in flowing H2-Ar. The Gd2O2S:Tb powder prepared with Tb(NO3)3 has higher XEL intensity than that with Tb4O7. Using the synthesized powders as starting material, Gd2O2S:Tb scintillation ceramics with high relative density (over 99% of the theoretical value) were fabricated by vacuum pre-sintering and HIP post-treatment in an argon atmosphere. The influences of the introducing method of Tb3+ doping on the microstructure, photoluminescence and X-ray excited luminescence of the Gd2O2S:Tb ceramics were studied. The ceramic sample prepared with Tb(NO3)3 has better luminescence properties due to the homogeneous doping in the ceramics. Temperature-dependent XEL measurements imply that the green emission of the ceramic sample is always dominant with the increase of temperature from 77 K to 340 K, attributed to the cross-relaxation between 5D3 and 5D4 levels of Tb3+.
materials science, multidisciplinary,optics