Abstract:Objective To determine the variation in contact stress on polyethylene liner of met-al-backed acetabular components in cases of different cup orientation and femoral head prosthesis diameter un-der different gait states including heelstriking, midstance, toe off and upstairs. Methods Three-dimen-sional finite element models of metal-backed acetabular components and corresponding ultra-high molecular weight polyethylene liners with femoral head diameters of 22 to 32 mm were developed. With the various stress loaded through the head center, contact force of articular surface was analyzed by nonlinear contact elasto-plastic finite element model. Results The cup orientation by different anteversion and/or abduction angles with different head diameters under various loading states affected the resulting contact stress markedly. Liner stress level increased with higher loading states like upstairs and/or smaller femoral head diameter. The peak liner contact stress values were found beyond the yield stress of polyethylene in femoral head smaller than 28 mm under upstairs loading. During walking at same speed on flat ground, the differ-ence of anteversion (0°-30°) and abduction (30°-60°) raised contact stress level of polyethylene liner fluctu-ating within 20% approximately, and all of the peak stress values were less than the yield stress of polyethy-lene. But under upstairs loading state, liner contact stress was found to increase either anteversion or abduc-tion angles. When anteversion angle exceed 15° with various abduction angles (30°-60°), the peak contact stress was all beyond yield stress of polyethylene. Conclusion Among the various designs and operative procedures available for surgeon to select, larger head diameter and proper orientation should be considered for the sake of efficient decrease of the liner contact stress. For patients after total hip arthroplasty, it is nec-essary to avoid or at least reduce higher loading activities.

The Shape of the Acetabular Cartilage Surface and Its Role in Hip Joint Contact Stress.

The Shape of the Acetabular Cartilage Surface: A Geometric Morphometric Study Using Three-Dimensional Scanning

Contributions of non-spherical hip joint cartilage surface to hip joint contact stress.

[Morphologic Features of the Acetabulum Bone Joint Area].

A Parametric Surface Model of Acetabular Cartilage Surface

Shape Analysis and Parameterized Modeling of Hip Joint

Dynamic Assessment of Contact Pressure Changes in the Hip Joint Cartilage During Daily Activities.

Finite element modelling for assessing effect of acetabular component orientation on the basic stress path above acetabular dome.

Biomechanics of acetabular CE angle and direction of hip joint acting force

Stress Analysis and Shape Design of a Femoral Hip Prosthesis

[Analysis of the Basic Stress Pathway above Acetabular Dome].

Periacetabular stress distributions during normal gait cycle and its guiding function in acetabular reconstruction of THA

A Modular Software System For 3d Measurement Of Acetabulum In Arthritic Dysplasia Hips

Fem Simulation Of Acetabular Cup Orientation

Importance of Maintaining the Basic Stress Pathway above the Acetabular Dome During Acetabular Reconstruction.

Morphological analysis of the acetabular cartilage surface in elderly subjects

Analysis of Finite Element Modeling on Elasto-Plasticity of Polyethylene Liner under Contact Stress after THA

Shape Design of Femoral Hip Prosthesis

[A Study on New Computer-Aided Modeling Method of Hip Joint].

[A Simulative Biomechanical Experiment on Different Position of None-Cement Acetabular Components Influencing the Load Distribution Around Acetabulum].

Anatomical Study of Acetabular Joint Surface Based on Reversing Engineering