[Morphologic Features of the Acetabulum Bone Joint Area].

Dongyun Gu,Kerong Dai,You Wang,Xin Hu,Juntong Xi
DOI: https://doi.org/10.3321/j.issn:1001-5515.2003.04.014
2003-01-01
Abstract:The research on the morphology features of the acetabulum bone joint surface area would be helpful to establishing the acetabulum 3D model for the purpose of the biomechanical analysis of hip joint, and therefore might have its important clinical significance. However, in former studies, the acetabulum was simply considered as a semi sphere. In this study, based on the acetabulum 3D-point data acquired by the 3D laser surface scanner and the reverse engineering technology together with the optimal fit algorithm, two kinds of best-fit model were achieved by a sphere surface and a rotating elliptical surface respectively approaching to the acetabulum bone joint surface. Both fitting errors were then compared and analyzed. The results showed that the fitting error of the rotating elliptical surface was significantly less than that of the sphere surface (P < 0.001). The average radius of fitting sphere was 24.37 +/- 2.22 mm and the average long axis of fitting rotating elliptical surface was 26.02 +/- 2.76 mm while its short axis was 24.17 +/- 2.16 mm. These findings would be helpful to our new recognition of the acetabulum since they were results of the first quantitative analyses for the acetabulum bone surface and also might serve as an important reference base in its further studies and application.
What problem does this paper attempt to address?