Abstract:Vehicles commonly suffer from the narrow-band noises and vibrations, usually a superposition of multiple sinusoidal signals, due to the excitations of engines, electrical motors, gear boxes, and other rotating mechanical parts. These excitations are transmitted to a reference point of some structure with certain transmission paths. The vibration signal measured at the reference point can be used for power system monitoring, fault diagnosis, modal analysis, noise analysis, etc. For convenience, researchers in a laboratory usually use shakers to generate expected narrow-band vibration signals acting on the vehicle structure reference points to simulate the vibration signals. However, there is a prominent difficulty in ensuring the amplitude and phase accuracy of each sub-frequency component simultaneously. In order to improve the accuracy of generating the expected vibration signal, this paper presents a multi-source vibration simulation control technology based on the tracking filter method. The main idea is to use the tracking filter to estimate the amplitude and phase of the target sub-frequency component accurately. Further, on the target sub-frequency, the drive signal of shakers is then corrected based on the amplitude and phase errors to achieve a more accurate target vibration signal. The amplitude and phase of each sub-frequency component in the excitation signal can be controlled independently. Compared with other Fast Fourier Transform (FFT)-based frequency domain analysis algorithms and numerical methods by solving the equations, the tracking filter method has a higher frequency resolution and higher accuracy. It can be easily realized in real time applications due to its simplicity. Finally, verification experiments are completed. The experimental results show that the multi-source vibration simulation control technology presented in this paper can achieve high-precision amplitude and phase on each sub-frequency component of the target vibration signals, which contain up to eight sub-frequency components.

Random Vibration Control Based on Adaptive Filter

Research on the Random Shock Vibration Test Based on the Filter-X Lms Adaptive Inverse Control Algorithm

Sine-On-Random Vibration Test Based On Multi-Resolution Spectrum Estimation And Wiener-Khinchin Theorem

A Fast Vibration-Level Adjustment Method for Low-Frequency Vibration Calibration Based on Modified Filtered-X Least Mean Square Algorithm

An Adaptive Feedback Vibration Control Algorithm

Research On Control Technologies For A High-Precision Multi-Source Vibration Simulation System

Concurrent Control Strategy Research for Non-Gaussian Random Vibration Test

Adaptive Inverse Control of Random Vibration Based on the Filtered-X Lms Algorithm

Control Designs for Multi-Exciter Power Spectral Density Replication Vibration Tests

Application of force limited control in vibration test

Control Strategy for Multi-Exciter Random Vibration Test

Research on Frequency-Selective Output Constraint Algorithm for Active Vibration Control

Super-Gaussian Random Vibration Test Control Technique Based on Poisson Process

Three-axis vibration control based on drive spectrum modified iterative control algorithm

Vibration Control of an Active Magnetic Bearings Flexible Rotor System Based on Adaptive Recursive Least Square Algorithm

Multi-frequency periodic vibration suppressing in active magnetic bearing-rotor systems via response matching in frequency domain

GENERATION OF TIME DOMAIN DRIVE SIGNALS IN MIMO RANDOM VIBRATION CONTROL SYSTEM

Active Vibration Control for A Rotor System Subjected to Random Excitation

Application of stochastic optimal strategies in vibration control for rotor system

Design of an Active Vibration Isolation Control Strategy Based on IFT Method

Active Control for Non-Autonomous Diaphragm-Type Pneumatic Isolation System by Using an Augmented Adaptive Sliding-Mode Controller