Abstract:Vehicles commonly suffer from the narrow-band noises and vibrations, usually a superposition of multiple sinusoidal signals, due to the excitations of engines, electrical motors, gear boxes, and other rotating mechanical parts. These excitations are transmitted to a reference point of some structure with certain transmission paths. The vibration signal measured at the reference point can be used for power system monitoring, fault diagnosis, modal analysis, noise analysis, etc. For convenience, researchers in a laboratory usually use shakers to generate expected narrow-band vibration signals acting on the vehicle structure reference points to simulate the vibration signals. However, there is a prominent difficulty in ensuring the amplitude and phase accuracy of each sub-frequency component simultaneously. In order to improve the accuracy of generating the expected vibration signal, this paper presents a multi-source vibration simulation control technology based on the tracking filter method. The main idea is to use the tracking filter to estimate the amplitude and phase of the target sub-frequency component accurately. Further, on the target sub-frequency, the drive signal of shakers is then corrected based on the amplitude and phase errors to achieve a more accurate target vibration signal. The amplitude and phase of each sub-frequency component in the excitation signal can be controlled independently. Compared with other Fast Fourier Transform (FFT)-based frequency domain analysis algorithms and numerical methods by solving the equations, the tracking filter method has a higher frequency resolution and higher accuracy. It can be easily realized in real time applications due to its simplicity. Finally, verification experiments are completed. The experimental results show that the multi-source vibration simulation control technology presented in this paper can achieve high-precision amplitude and phase on each sub-frequency component of the target vibration signals, which contain up to eight sub-frequency components.

GENERATION OF TIME DOMAIN DRIVE SIGNALS IN MIMO RANDOM VIBRATION CONTROL SYSTEM

AN IMPROVED OPTIMAL ADAPTIVE CONTROL METHOD FOR MIMO SINE VIBRATION CONTROL OF A MULTICHANNEL COUPLED SYSTEM

Three-axis vibration control based on drive spectrum modified iterative control algorithm

Research On Control Technologies For A High-Precision Multi-Source Vibration Simulation System

An Adaptive Control Algorithm for Harmonic Cancellation in Multiple-Input Multiple-Output Vibration Systems

Concurrent Control Strategy Research for Non-Gaussian Random Vibration Test

Command Filter-Based I I Adaptive Control for MIMO Uncertain Systems with Input Saturation and Disturbances

Super-Gaussian Random Vibration Test Control Technique Based on Poisson Process

A Vibration Mitigation Approach for Inverter-fed Permanent Magnet Motor Drive System

Bounded Time-Delay Control Performance of Two-Degree-of-freedom Nonlinear Vehicle System under Random Road Excitation Using MR Damper

Application of Fuzzy Adaptive Control to a MIMO Nonlinear Time-Delay Pump-Valve System

Multi-Objective Optimal Design of Μ–controller for Active Magnetic Bearing in High-Speed Motor

Modified time domain randomization technique for multi-shaker non-stationary non-Gaussian random vibration control

Investigation of multi-input multi-output sine on random mixed vibration control

A Novel Dual Random Scheme in Signal Injection Sensorless Control of IPMSM Drives for High-Frequency Harmonics Reduction

Adaptive Inverse Control of Random Vibration Based on the Filtered-X Lms Algorithm

Synchronous control of tri-motor vibration system considering an adaptive back-stepping control strategy

Command Filter-Based Adaptive Fuzzy Self-Triggered Control for MIMO Nonlinear Systems with Time-Varying Full-State Constraints

Adaptive Immersion and Invariance Tracking and Synchronization Control for Multi-motor Driving Systems with Parameter Uncertainties

Real-time robust generalized dynamic inversion based optimization control for coupled twin rotor MIMO system

Design of a Resonator Vibration Control System Based on Parametric Drive