Abstract:One of the biggest impacts of the vision ‘Internet of Things’ is the massive number of connected devices, where billions of nodes will exchange data, information and commands. While wireless systems offer advantages such as increased flexibility, they also introduce one major challenge: how to power each individual node. In many cases, there is no way around the use of batteries. To minimize the environmental impact, increasing the battery’s longevity is the most important factor. This paper introduces a wireless battery-assisted node that has a drastically reduced energy consumption in the standby mode. The state (on/off) will be changed by harvesting a radiofrequency signal. A latching switch connects or disconnects the load—for example, a microcontroller—and the battery. The switch is connected to a charge pump which converts an AC (alternating current) signal into a usable DC (direct current) control signal. An antenna is mounted to the charge pump via a matching network. An electromagnetic wave is emitted by a remote control switch that switches the system on and off. The used frequency is 868 MHz and therefore in the UHF RFID (ultra high frequency radio frequency identification) band. The measurement results show that the wireless node consumes less than 16 nW in the standby mode. The remote controlling is possible from a distance of more than 12 m . The presented system can be integrated in further work on a UHF RFID tag. Thus, the existing protocol standard can be used to identify the object to be switched. By custom commands, the switching request can be transmitted from the remote control (UHF RFID reader) to the switching node.

A RF remote-control transceiver with zero-standby power based on RFID technology

A Passive RF Receiving and Power Switch ASIC for Remote Power Control with Zero Stand-by Power

Remote Control System for Battery-Assisted Devices with 16 nW Standby Consumption

A Low-Cost, Low-Power UHF RFID Reader Transceiver for Mobile Applications

A Low-Power RF Front-End of Passive UHF RFID Transponders

An Ultra Low Power Digital Processor for Chinese UHF RFID Transponder

A Switch Type RF Energy Harvesting and Management System

A Low Power Low Cost Fully Integrated Uhf Rfid Reader With 17.6dbm Output P1db In 0.18 Mu M Cmos Process

An Ultra Low Power ASK Demodulator for Passive UHF RFID Tag

A 0.66mw 400 MHz/900 MHz Transmitter IC for In-Body Bio-Sensing Applications.

An Ultra Low Power RF Frontend of UHF RFID Transponder Using 65 nm CMOS Technology

A 0.65μW baseband processor for UHF RFID with on-chip antenna

A 2.4 GHz 2.9 Mw Zigbee RF Receiver with Current-Reusing and Function-Reused Mixing Techniques

A 6.93 µW wake-up circuit for active RFID Tags

Low Power Design of UHF RFID Tag Baseband Processor

Design of a 0.6-V, 429-MHz FSK Transceiver Using Q-Enhanced and Direct Power Transfer Techniques in 90-nm CMOS

A 35 Pj/pulse Injection-Locking Based UWB Transmitter for Wirelessly-Powered RFID Tags

A 2.4ghz Low Power Wireless Transceiver Analog Front-End for Endoscopy Capsule System

A 136μw over 800m Range Backscatter-Like UHF Band Transceiver

Novel baseband processor for ultra-low-power passive UHF RFID transponder

An RF-Energy Harvester and IR-UWB Transmitter for Ultra-Low-Power Battery-Less Biosensors