Abstract:Conventional Phase Difference method pinpoints the PD location by analysing the phase difference of the primary arriving signals at both terminals in power cable, however it lacks consideration of signal separation in noisy environment and fails to ensure location accuracy when defect is close to cable end. Based on the analysis of PD pulse propagation character in cable system presented in the first part of this paper, an improved online PD location method is then proposed. Measuring instruments are installed at both terminals to collect real-time pulse signals and deliver measured signals to the processing center. On the basis of the cross-correlation function analysis, the direct and the first reflected waves measured at both ends are identified and separated from interference. Implementing the cross spectral density function, the phase differences of two pairs of signals are then obtained and the defect is finally determined by integrating the two location results. The situation when PD locates near the cable end is as well analyzed on considering the mechanism of wave reflection and overlapping, so as to increase the accuracy and reliability of the PD pulse location. The performance of the proposed technique is tested by simulation under ATP-EMTP on considering the noisy environment and the situation when the defect is close to the cable terminal. The comparison with other methods and the analysis are presented at the end of the paper.

The experimental study of transmission characteristics of the PD and interference signals in the cross-bonding link-system

Radio-frequency Detection of Partial Discharge in Power Cable Joints

Propagation stage characteristics of electrical tree in 110kV XLPE cable insulation at 50Hz power frequency voltage

EXPERIMENTAL STUDY ON THE PROPAGATION CHARACTERISTICS OF THE PD PULSE IN XLPE POWER CABLE

Experimental research on partial discharge localization in XLPE cable accessories using multi sensor joint detection technology

Propagation Characteristics of Partial Discharge Signals

Time Domain Simulation of PD Propagation in XLPE Cables Considering Frequency Dependent Parameters

Simulation Of Partial Discharge Propagation Characteristics In Xlpe Cables And Joints

Numerical Analysis of Partial Discharge Electromagnetic Wave Propagation Characteristics in XLPE Cables and Joints

A Comparative Study on Partial Discharge Characteristics for XLPE Cable.

Simulation Study and Detection Position Analysis on Position of Partial Discharge Detection in XLPE Cable Cross bonding System

Simulation Analysis on the Characteristics of EM Wave from PD in XLPE Cable Joints

Studies on the VHF Detection of PD in HV Cable and Joint

Amplitude Distribution of Partial Discharge Signals on Tunnel-Installed High-Voltage Cables

Propagation Characteristics of Partial Discharge Pulses in the Cable

Influence of Cross-linking Characteristics of DC Cable Insulation on DC Performance

Studies on electric field distribution and partial discharges of XLPE cable at DC voltage

An Improved Method Based on Double-End Phase Difference System for On-Line Cable PD Location

Characteristic admittance model and PD amplitude distribution of tunnel-installed high-voltage cables

Study on Characteristics of Partial Discharge in Xlpe Cable under Damped Ac Voltage at Different Frequencies

Study on Interfacial Charges of Double-layer Crosslinked Polyethylene